On Sun, Sep 22, 2024 at 05:39 PM, Bob Polmanter wrote:
0. Don't clear the stack, but read it, so when you IPL XNET you could stack D NODES and D TASKS to show up in your spooled console?
XNET doesn't run under CMS; it takes over the virtual machine and runs natively immediately after launching.? How about instead if the XNET CONFIG file allowed commands to be placed there that would be executed upon start up?? Note that there wouldn't be much shown or revealed by these commands if the CTCs are not yet connected and no one has yet DIALed to XNET.
?
?
1. SMSG capability, so I could SMSG D NODES and get the response back.
2. A restart capability, via SMSG? to reconnect systems when a failure happens.
Interesting ideas; I hadn't thought about the SMSG feature.? I'll look into these solutions for winter projects.
?
If you tackle the SMSG, then we wouldn't need commands in the CONFIG, as AUTOLOG1 or OPERATOR or ... could just SMSG the command to get the results, especially if there was a SLEEP to allow time for connections to stabilize.
?
?... Mark S.
Mark A. Stevens