开云体育

Hi Larry, I haven’t heard of problems using Chirp with the FT8x7 group of radios although I have previously used FTBasicMMO for programming mine (817, 857 & 897) and always had good results with

I am using my 817 again. I've had it since a year or two after they came out. Gets used in spurts but I have never used programing software such as CHIRP.? Main reason is that once upon a time I read

Great advice! Em seg., 20 de jan. de 2025, 17:42, Jeff WN1MB via groups.io <jwbauer= [email protected]> escreveu:

I have managed to work stations in 6 m FT8 (FRONT), 2 m and 70 cm FM (FRONT) and 10 m FT8 (REAR) after. As you've said: probably nothing damaged. Phew! Em dom., 19 de jan. de 2025, 15:02, Mike Davis

I like the way you think, Barry! Though real estate within the FT-817 case is at a premium, including an automatically switched load for the unused antenna port would have been a superb design

I allways put a 50ohm dummy load on the antenna output that is not in use. Having to replace the output pa transistors in not fun and expensive. I hope this solves some of your concern for the pa on

I think the FT817 screen will show a high SWR warning and foldback the power output, I’ve been in the same boat before and no harm done. 73 Paul 2E0YOB

I had a poorly tuned 2 meter dipole, purchased online, antenna that made my FT817ND display flash a warning message of high SWR(???) during RTTY transmissions, and the finals never failed.? (maybe

The 817nd is pretty robust,? I've had a 70cms 5w usb qso over 10 miles without a connected antenna. Other than a weaker than normal signal no damage done. You should be fine. Andy

If it is still putting out the expected power, it's OK. [email protected]> wrote:

That’s hard to tell. Probably nothing damaged if you are still able to transmit on all bands as expected. I know the concern. But if it’s working normally, it’s not like you’ve partially hurt

Today I was racing the bands so much during a POTA activation that I noticed I CQ'd two times 5 W in FT8 on 6 m using the wrong output (antenna was in the rear but the menu was selected FRONT). After

You are right. I was mistaken. I thought blinking only works with a built-in battery only. I just checked out, the indicator switches from none to blinking, with external power with a voltage less

Not really. Blinking indicator means the radio produces 5W, but voltage is less than ~11V. This works with a built-in battery only. With the external battery there is no blinking indicator at all, the

Following Blasco's advice, today I used a Powerwerx meter: With Bioenno (LIII not blinking but with all 9 bars from PO indicator lit): RX: 0.35 A, 13.06 V, 4.7 W TX: 2.3 A, 12.90 V, 29.6

Michael, The damage that can be done to the FT-8xx series of radios is why Yaesu recommended to the HAM RADIO DELUXE folks to remove the capability to read/write to that same area. The later versions

Check chirp website [email protected]> escribió:

I've seen a price in Europe of 999 euro ......another hop says 9999 euro. It can be ordered for 999 at the specific sellers store. Will be available early 2025 73 Kees PA1CJT Op 12-01-2025 om

Supposed to be coming in February the last I heard. This is, so far, the least publicized radio I have ever seen. 73 Kevin Mullens K5KTM

Hi Dave A google search shows Gigaparts it can be reserved for $35.00 but that is all I see right now. The picture in that ad shows a nice looking rig. Not sure I need another rig right now so I