开云体育

G’day Leicester, Good question, wish I could give you an answer! Perhaps the 817 and the 818 are just different enough that a clone from one to the other won’t work? Maybe another approach like

Sent: Sunday, 20 October 2024 4:28 PM To: '[email protected]' <[email protected]> Subject: Clone FT817 to FT818 Hi All, I'm having trouble trying to clone a FT817 to a friend's FT818

As a reminder, Yaesu shipped the FT-817, FT-817nd, and FT-818 with not only a battery pack, but also an antenna collection (2m, 6m, and 70cm) and shoulder strap. They obviously viewed this as a

Pietro, Sorry to have been away for a few days.? I looked at your pictures of the display and the SWR does seem a little high.? The radio cuts back on power when the SWR goes up to protect the

Just like going to the dentist. Did Ali Express finally deliver? I’m hoping my battery pack gets her soon. We ordered our parts about the same time. Mike Davis WA1MAD

Hi were did you get them from in the end, Dave 2E0DMB wrote:

The radio doesn't want you to do surgery on it! LOL Ken, N2VIP

I got the pin diodes but suddenly, yesterday, it starts to work at full power. Astonishing, disorienting... I2OIM

Hi Tony, The current rating looks adequate though marginal.? Hopefully it will be RF quiet as well.? If you have RFI from it look into the Pro Audio Engineering Kx33, as far as we know it is the

Sounds like a good time, we should all come. Kevin Mullens

Splendid

From the user manual Current Consumption: Squelched: 250 mA (Approx.) Receive: 450 mA Transmit: 2.4 A (HF/145 MHz), 2.7 A (430 MHz) You're good to go. G4MAD

Hi, I have picked up a WhatsOn 3A Power Supply that plugs into the mains. Will that work ok with the FT818nd as it can deliver 3A continuous. Dont want to plug it in just in case without confirmation

I should have said “Congress Hotel.”

Bob: Perhaps this message about the Chicago Hotel is misdirected. Jim

Boersma has just told me that he will get the Congress Hotel booking codes in January... I'll alert you whe he has them... Bob

Hi all, you could check the following page as well, if you haven't found it already... https://destevez.net/2015/12/installing-the-g4hup-pat-on-the-ft-817/ 73, DIck

Hi Mike and Jack, The tap points in an 818ND, or indeed to the late models of 817ND, are pretty much in the same place as they used to be: +RxB still on that one via, the signal on either the output

Yep, and fully understood ;-) My so called bench PSU failed a few years back, not got around to replacing it, but I used to use that for charging my 7ah gell cell. (Will one day build my own when I

That is a helpful analysis, especially if you have the schematic at hand. My practice is to print the schematic, then trace the various signal paths on it with different color highlighters. ?After