开云体育

Thanks Nick for the trick. I downloaded his software. But that widely opens the 817, not only the second part of the 40m Band (or the 60m Band). Is there another kind to open just our ham’s bands

Try a search for "M0BMN widebander". That was the software I used to use to unlock coverage for 60 meter operation.

HI all, I am trying to repair an early model FT817. It is fine on all bands/modes in RX.?It is fine on TX in all modes, *except for 18Mhz (17m) and 21Mhz (15m)*. In the affected bands, measured in

The Windcamp battery also works below 10v. [email protected]> wrote:

Hi all, sorry to undig this topic but I'm testing a FT-817 for a friend and saw that exact problem : TX ERR above 7.100 kHz. Could someone gives me a start point, as the previous pdf link is not

Hello, I'm using a generic CAT bluetooth device paired with a DIN/P2 cable connected to FT8CN for an FT8 interface. Out of whim, once or twice, if I TX at 5 W on 10 m, the ALC goes to 0. If I change

Or, it's tired. May need a new one. Mike WA1MAD [email protected]> wrote:

I was thinking the same thing. The Windcamp is a 3 series lithium-polymer. Cutoff being between 2.5-3.0V per cell at the lowest, and 3.0-3.5V per cell on the conservative side, could easily land you

Just a thought - if the battery has an integrated BMS then it may be that that's cutting out rather than the radio. Cheers, Ronan MM0IVR

Just to add that it's best to measure the voltage at the dc connector so as to take into account any voltage drop in the power lead. Also IIRC Yaesu recommend using 13.8v as input if calibrating the

The radio will work below 10v, the stock NiMh pack is 9.6v, you usually won't get full power at that voltage. There is a volt meter calibration in the service menu. I have done this, as in measure

The Radio or the battery?

I thought 11 volts was the minimum it would work at. Zack W9SZ [email protected]> wrote:

I did a POTA activation for probably 1 hour of transmission time before it shut off. Possible a little more? Can’t remember for sure the exact time. Thanks

Yes, I think that's normal. I have the exact same radio and setup, but with a new Windcamp setup. I've yet to deplete it, but haven't used it much . Maybe the older windcamp battery is just tired, or

Hello group! I recently bought a non- ND model Yaesu Ft817 that has the Windcamp 3000mah battery installed. I can charge the battery up to 12v but, once voltage drops down to around 10v the rig shuts

I have used the Bob Freeth G4HFQ program available at https://www.m0lxq.com/g4hfq/download.html There are also programmes available for several other Yaesu radios; I use the 7900 & 8900 versions

I have used CHIRP for programming for many years.? I have used it for FT817, FT818, FT70D and UV5R radios of my own and two or three for other people.? I also mentored others doing it themselves.?

Hi Marco I have to agree at least to the fact that I also use CHIRP and also have YAESU radios that I have copied the memories from to keep as a backup and restore or clone. Recently also have copied

I wont even try to say a word about CHIRP bricking or not radios as I used to be one of the developper and specifically the original author of 8X7 modules BUT I can't repeat enought times that CHIRP