开云体育

What modes you use? Does the power bank or the cable heat up? Em ter., 11 de mar. de 2025, 11:03, sharudin senapi via groups.io <aidiesha= yahoo.com@groups.io> escreveu:

HiI am using Power Delivered USB C that can produce 12v to my 817 73 9w2d

USB-C can natively handle up to 5 amps.? Your phone has the circuitry built-in to use up to that amount.? As long as its 12V and <= 5A then you are good to go! Ryan NE1AM

I was wondering if it is possible to have a power bank to charge my phone (while hiking) and also to have it as a backup power source for the Yaesu. Not only voltage and current ratings on websites

Mostly heat in the transmission line and finals. If it's an antenna with radials on the ground, resistive ground losses.

Wow..I didn't know it was so lossy! Out of curiosity: the case of one radiator, where does the 2/3 of the power go? Daniel PY2TDB. Em dom., 9 de mar. de 2025, 17:06, James Todd via groups.io

Daniel: If black is the radio, which is about 20 cm, they are functionally equivalent. ?Neither is optimal, however due to the radiator of the antenna you described being shortened by about 1/3

Hello, I have a question: Are these setups equivalent (radiation-wise)? Purple: Portable antenna for, say, 10 m (think of a GRA-1899T) Blue: Ground/radial of 2.5 m Black: Yaesu [image:

OK so, my ssb mic gain is now 50, without compressor my ALC shows no bars, with compressor it shows 3 bars. Power meter, set to PEP not AVG no compressor shows 1.5w with 5w on a whistle but with

A compressor will increase average loudness and thus power, but readability is reduced as it is increased and beyond a point very much. Those with hearing impairments may find readability reduced

I had the laserbeam filter unit installed in my 817nd for a while. It does work but has a couple of annoying side effects. Well, at least mine did. First, the metering for signal strength is thrown

Another option is the external 4StatesQRP HI-PER-MITE audio CW filter kit . ?This filter ?is 200 Hz wide and has no ringing - a truly ?amazing 4 pole filter with 3 low pass filters and 1 high pass

Hi Mike, check YouTube, I think he has an or mor Videos See under ?Sotabeams FT-817“ I hope this helps for your search on YouTube. 73 de Martin, HB3YDM

How difficult to install the Sotabeam unit? Mike Davis WA1MAD

Hi all, My mic gain is 50 ssb mic. With the compressor switched off and radio set to 5w and a 12v car battery operating into a dummy load an external power meter shows peaks of 2.5 to 3.5w. With

Hi Andy, I have the same speech compressor from Sotabeams, just out of interest what mic gain setting do you have the FT 817 at with the speech compressor switched on? Thanks Phil 2E0GUK

I have no experience with the BHI filter, however I installed the sotabeams filter in my 817 and it's great. All filter switching is controlled from the buttons on the radio. You do have to move the

Hi Andi, I don't quite understand how to adjust P2? I haven't read the manual yet, because I thought it was a plug and play product, so you have to adjust the voice a bit as I understood you? I wonder

Thanks for your feedback Andy. I tested in ssb an FT-817 with a external swr/wattmeter and was very surprised to see no more than 2.5w even with ssb mic gain set to 95 and shouting into the mic ! I

I assume you read this. https://www.sotabeams.co.uk/ft-817-filter-module-ssb-cw/ Mike WA1MAD uska.ch@groups.io> wrote: