开云体育

It is probably set to the earlier European 40m model, 7.000 to 7.1000. The ND model cannot be programmed externally, you will need to open it up and do the solder modification. Mike – KD5KC

One of my FT817nds (serial no 4H) won’t transmit on the top half of 40m. My other one is fine and this one works on the lower half and on all other frequencies. I’ve just started using this one on

To be sure, look at the numbers on the connector. -- Al Skierkiewicz WB9UVJ

Do need to watch these connector pin-out diagrams.? Once wired a Yaesu mobile rig mic connector for a digital interface and on one side was 5V pin from inside the rig and on opposite side was PTT

Hi Mark I think so, but you may have to use a meter to confirm that. I have looked for a confirmation and never really found a printer form. It has been a lonnnnng time since I have assembled

Steve and Marty, Thank you for your responses. The service manual is a keeper for sure. I found what I needed from the schematic on page 29. It shows the 8-pin Mini DIN configuration and the pin-out

Check the HL45 schematic. It has remote circuitry inside.Sent from my Verizon, Samsung Galaxy smartphone

Speaking of power amplifiers and pinouts, does anyone have any resources for building your own remote for the Tokyo Hy-Power amplifiers? I've had a watch on ebay for going on 4 years to see if an

Hi Mark Here is a link, you may have to scan it with mouse, to the FT-817 service manual. On page 23 of the PDF is a picture of the CAT and DATA and all of the plugs really. I don't know if it will

Strike that Mark, all I've done is confirmed what you've said you're doing. Pin "8" is "TX Inhibit". I 'll leave this to folks that do know what they're talking about ...

Hi Mark, that seems correct to me, but I'm going by the diagram at the bottom of page 113 of "The Pack-it Reference for the Yaesu FT-817". Steve, G4VRR.

The documentation for wiring the ACC plug from the MX-P50M power amplifier is sparse. I realize it should be simple with the black control wire going to the GND and the red control wire to the TX GND

Mark, I run Flrig 1.3.51.02 (alpha testing it), and have run all previous versions, with my FT817nd with no problems.? Early on when I first got my FT817nd, I found it "worked" at high baud rates,

On a whim, I decided to monitor my local repeater yesterday while working from home. I brought my FT-817ND into the 'office' and ran it off the internal Windcamp battery for most of the day in listen

Try 817companion.com? I just downloaded it to my S10+. Clyde Lambert KC7BJE

Yep, It will happen forever while people have weak passwords. I find that a simple, quick flick of the "del" key means that the problem is solved from my end. Kindest regards, Doug Jackson em:

The last time I tried 817 companion it had connectivity issues. May have just been me. 73 Mike n4mdp

Hi Ivo, Please send me an e-mail with more details about your setup. 73 Dan YO3GGX

Even the best run systems get an occasional SPAM leak. It happens. DELETE, and move on. We don’t need 50 people complaining about it, and 100 more agreeing. Sometimes the reaction is worse than

https://www.amazon.it/817-Companion-for-Ham-Radio/dp/B012AFC8GQ https://817companion.com/ I0PCB Attilio 28/07/2020 MESSAGGIO ORIGINALE Hello, where to download or buy an older "817companion"