Okay everyone, I think I may have joined the blown final club.
I was listening to the maritime mobile net on 14.300 and thought, what the hell? See if 2W might get the net control’s attention.
The 817 reported ‘highswr’ on the rear antenna port, so I went to the front and the highswr went away. However in both cases, the power meter only had on bar lite even though power for set for four bars.
Highswr into a dummy load on rear port.
That’s not right! So, even though the power jack is fubar, I can squirt in DC and at 13V input, I still get from 1 to 0 bars and the radio is only drawing 530ish mA.
That sure sounds like a pop PA board.
Makes no difference if I’m on HF or VHF, no bars or 1 flickers a bit. I can hear myself on another radio i.e. 146.52 rx and while tx on the 817.
This is an older 817, I don’t know the vintage, so this being the weekend, does any one know the approximate cost of a new PA board from Yaesu? Can you still get ‘em? Is the PA even bad?
Mike wb8vge
FYI…. I put my other 817 on line and the net control gave me a s9 report. I am in ohio, he was on the west coast. That Yaesu 817 is an amazing little rig!
