开云体育

I sugest to take the machine apart clean fix or repair parts and re assemble. This is a simple machine not a rocket any one can do it than u will understand what u have. Service people will charge way

I’m happy to make anything there is a demand for… Bill

Before you have someone run out there, have you sprayed penetrating oil on the parts that accomplish the raise lower? Marlowe McGraw [email protected]> wrote:

Hello everyone, I have an older (1994) BF6-41 that needs service. I bought it used and I am trying to get it up and running.? the table saw blade wont raise or lower.? is there anyone near Ohio that

Well maybe Bill needs to add a right angle adapter to his collection. If it helps Felder offers 120 to 100 straight adapter Art. No. 02.2.021

Habacomike, This was my previous set up with a 15” planer and the dust shroud ran right into a 4” 90 fitting. Planer is in the background of the photo. It worked great with everything I ran

Brian, It’s a valid point. But I’m willing to try it only because I’ve been running a 15 planer on this same set up for nearly 20 years with no issues. The flex hose runs right into a 6” hard

?Mark, “A phase convertor manufactures a phase shift, not a voltage change. It takes voltage in that is 180° phased, and shifts to 120° phased, basically by storing electrons for 60° of time,

Wouldn’t a straight connector offer better air flow (less turbulent flow)? That might be important given that your ducting is undersized...

Necking down the dust collection hose on a 16” planer is just asking for clogs on a routine basis. I would use 5” at a minimum. Brian Lamb blamb11@... www.lambtoolworks.com

? Imran, Thank you. Bill does offer a 120mm to 4” hose. See link. But it’s not a right angle. Now if he offered a 120mm O.D. to machine connection, then it curved 90 degrees to an end that

Wade, I use 5” spiral with Felder adapter and I assume Bill Belanger adapter does the same. Which ever way you go, just confirm that the hose end matches your requirement. Imran Malik

Imran, Great point about clearing the hose out of the path of outfeed. I’d like to go with the right angle adapter setup, but I’m also wanting to keep my hose size to the 4”+ that it is. ?

Hi, sorry, I think I got confused as to which reply tab to select. The right angle connector part number 02.0.020 is a snug fit due to the taper. It is easy to attach or remove from the machine yet

Hi Ray, it’s best to talk to someone at Felder as some of the options group into a discount that doesn’t exist if you custom select every item individually. Regards, Rod P,S. Also the sales rep

To be clear, each hose has its own 90 deg adapter. My adapters are from felder and they slide on/off easily and fit snugly. I have no doubt that Bill’s offering should be just as good. He should

Hi All, Is there a place to find available Felder options and list prices for machines? EG option and cost for the cutter block on the planers, etc. I have looked in the files section and saw nothing.

Agreed on the quality comment, but these guys have been around a long time and are very reputable. They sell a lot to machine shops that need carbide blades for big industrial horizontal bandsaws.

Thanks Mac.? I had never considered setting up a machine that way, but I love the idea.? I'm going to look into how I might do that to my drill presses.

Brian:Thank you. I identified one in my neck of the woods… Baltimore, had Starrett not stepped-up. My concern was that there appear to be many garage-shops for?which I have no sense of quality.