开云体育

I have a pair of Bench Dog push blocks I use with my jointer and I like them a lot. The foam pad no longer grips. ?They are. I longer available so I need to either replace with a suitable foam or get

Here some pictures, originally wheels were in the other direction.

Thanks a lot Jim, it all makes perfect sense now. Firstly I couldn’t work out wheels arrangement and then it I have noticed I just need to swap wheels directions. David, reading back my post I get I

$13,199 on eBay, and $5,740 direct from HGR. Something fishy there. -- John Hinman Boise ID K700S and A941

Here is the same saw on Ebay and condition is “for parts or not working”. Definitely a concern. EUC-FELDER K700S TABLE SAW 02240570001 ebay.com Imran Malik

Great find, my go chuck is Pratt and burnerd On my Dean Smith and Grace center martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell

I absolutely agree that you need to know what you are doing with HGR. But as I said I am fortunate to being only 100miles from the warehouse in Ohio. So I collect my own stuff (although that says

Neil, I bought from HGR for years. They are absolute bottom feeders if you’re a machinist and you know how to rebuild machines then say you have some pretty good deals sometimes for somebody

Thanks Niel. FWIW, a member of my FB group alerted me to this saw a week ago. His msg said, “saw this at HGR in cleveland ohio, nice saw”. Not sure if he is a member here. Imran Malik

I have been a long time member but my posts have always bounced due to older email address on record (hopefully correct now). This is simply an advert I saw!

?The terms “rolling carriage” and “fix it to the spindle” do not compute. What is the product you are asking about - “rolling carriage” could be any of about 4 different things, none of

Peter, I brought this machine into my shop earlier this year. Attached are three photos of the rolling carriage: 1. The Felder drawing shows the exploded assembly. For my machine it was reversed; the

Hello all, I just managed to pick one up second hand one, Felder rolling carriage and it came without manual. can anyone be so kind and share few pics how to fix it to the machine F700Z spindle? many

Hi Henry, Well done. FWIW, I put a single page document as a guide for folks who want to run a multi motor machine on the VFD. It may not be very useful to you at this time but would appreciate your

Following up here: I ended up deciding to build a new control and switch the machine to 3P. I bought three like-new 2.2kW 90L motors off eBay (~$1k total) and used terminal blocks and a contactor to

Those beam saws aren’t nearly as scary as one would think-I have the similar sized 400mm Makita and it’s a joy to use. Have fun with it! Stacked dado blades on a shaper arbor is way scarier to me

Honestly I would cut the leading lines with the table saw and the rest with a coping saw and clean up with chisels. Im also doing some tenons now what are 9cm deep, did one cut with the table saw and

In addition, if you do end up buying two, they can be used for and square shoulder tenoning down the line as well.

In that same puckering vein, I just bought a 16 5/16” Skil saw on Prime day for some future beam projects. This plus a chisel would make quick work of some slots but you’d need to do some

Hi David, Thanks for the generous offer of lending me the tooling but I would be worried sick if I did something wrong with them. Do you have the hood for Profil as it accommodates 350 mm tooling? One