开云体育

Thanks Randy. That would be awesome. Imran ? Good morning Imran.. I don't believe my saw will start when the cover is open. But I will check again just to make sure.. I too, want to find out if my

Good morning Imran.. I don't believe my saw will start when the cover is open. But I will check again just to make sure..I too, want to find out if my cover is opening too far as well..From the looks

Randy, Make sure that your saw does not run with cover open. In my case it does. You want to be aware if that safety feature is not there to protect you. Imran ? Hi David.. Hmm..I wonder if mine has

Randy, I am sorry that I did not notice that you had added pics until David mentioned it. They were at bottom of the email string. Reason, I did not follow right away what you were communicating.

Hi David.. Hmm..I wonder if mine has an issue as well if it's not suppose to hit the lower carriage.. I'm going to look at the parts diagram and see if there's something missing on the both of Imran

Imran, here is a photo of the blade cover in the open position on my K975. I don’t remember what keeps it from opening so far that it bangs into the lower carriage of the sliding table like

To give some update, I was able to correctly setup the temple bolts on the outfeed table to get the cutterblock parallel to the outfeed table. I used the carbon paper trick but I used it with the

Thanks Randy. So nothing else preventing it from opening further than hinges? Imran ? Your blade cover opens a lot further than mine..mine hits the bottom, lower side of my sliding table carriage

Your blade cover opens a lot further than mine..mine hits the bottom, lower side of my sliding table carriage and rests against it..I dont think its suppose to open any further and definitely not flop

Got my saw hooked up today. In checking safety items I noted that the blade cover microswitch is functional but the cover drops beyond horizontal and the control lever completely disengages from the

Happened to me just last month, it’s a lost cause... Regards, Mark

Make sure your power driver is set to Fwd when tightening the lead screws. I had it set to reverse, the screw came out of the captured plate. Took me a while to get it back on the screw. I could not

Hi Randy, You won’t find much hand holding when it comes to Industrial cutters and machinery. In Germany only a Meister can start a wood shop unlike in North America were anyone can. Anyone who gets

When I got this dado set, I thought that for $1100 it should be cutting pretty much flawless dado's and was shocked to see that it was worse than a cheap knock off dado set..?Carl Knapp of Felder

Good Stuff Randy glad you found the issue. I did check this with the set I was asked to test. Bad cutter setup was the first thing that came to mind. The problematic issue you have brought light? is

I'll be taking one shortly and will post it tonight.? I was thinking of how all this could have been avoided if Felder had just left some sort of instructions with the dado blade

You need a tool setter all different styles from a small block of Alu with a shoulder lots of times comes with the tool . Basic,,, to fake arbor with dial indicator to check hights

You don't happen to have a picture do you? -- Michael Garrison Stuber Sent from Nine ________________________________ Sent: Friday, January 24, 2020 09:00 To: fdiemoz@...;

Ok.. It was the chipper tooth that cleans out between the nibbler tooth.. they were not seated properly.. David Best and I both agree that Felder really needs to up their game on their technical data

I used a local outfit called Sundance Transport out of El Dorado (near West Sac) ( www.sundancetransportinc.com ( http://www.sundancetransportinc.com ) ) at a very reasonable cost for moving the K700S