开云体育

Well, It is a mystery why David’s did not open as far as Randy’s. Mine is opening farther because I have yet to install the slider. Imran ? I had the K915 and that cover would only open until it

I had the K915 and that cover would only open until it hit the sliding table. I often wished it would open wider. Maybe your slider goes back further. Bill Belanger [email protected]> wrote:

Hi Imran Ok..I spoke with Greg Bryson at Felder and he checked into the blade guard and looked to see if there was any sort of "Stop" for it to prevent it from tilting down too far.. he said there is

After further musing, I've come to the conclusion that as sexy as the FAT 300 tables are, I'm probably better off directing my resources towards a KF-700. In the mean time, I'm still not super happy

I'll check it out.. can't be too hard to make..

David Best has pictures and such on his Flickr feed Brian Lamb blamb11@... www.lambtoolworks.com

Whatever works best for you..that's what you use..that goes for anyone

It would, I have to try and figure out how to make one for my k975..only the center part of the insert..there's 3 inserts on my saw

Not really, set the zero clearance insert high so that it is perfect to the slider, it’s just some jack screws. The few times I’ve done a dado like that I use the shaper spindle, or a router bit

Then your slider would have to zeroed to the cast iron or the zero clearance insert. I'll stick to my Freud for Melamine.?JohnJMK Services

Zero clearance insert would help. Brian Lamb blamb11@... www.lambtoolworks.com

I dont think anything is perfect..no matter what is used.. a lot of variables come into play..material, any sort of vibration, user error from feeding..etc.. it's all a matter of how OCD we choose to

That was an excellent thread before the forum got stupid with over moderation and most of the people with a brain left. Joe has always been an amazing source of information. Earlier I got a bit of

https://forum.canadianwoodworking.com/forum/tools/power-tools/1032011-zuani-tooling-from-rangate/page3 see post by Joe Calhoon on this thread of that public forum.

All, This is a very timely thread. I've CC'd Bill Wickett at Rangate so he can see what has been discussed. Bill is working to develop a dado cutter for sliders and I'm sure he'd be interested in any

That's definitely a better cut then your first picture but I'm sorry still unacceptable with those large chunks it blew out. For the price of the set not good and about as good as I could get back

I don’t have dado capability, so this may be a dumb question, but are you only using that half of the cutter for a 1/4” dado? If so, you have side scoring cutters on one side of the groove only. I

more pictures

Ok.. after my visit to the Felder office to have my dado blade checked out, here is what we discovered, and this is what we did to correct the issue. First off, I learned, was to check to make sure

Thanks Randy. That would be awesome. Imran ? Good morning Imran.. I don't believe my saw will start when the cover is open. But I will check again just to make sure.. I too, want to find out if my