开云体育

I'm having some issues with the PP PTS005 I installed yesterday running a 2012 AD741 with digi-drive that fits in this thread. I had been using a rotary phase converter to run the AD741 with no

Tom, The T130 is certainly a nice machine (you have an amazing setup!), and I have considered it. I could have picked up the T130 in the MachineryMax auction that Jared mentioned above for a good

There was a nice looking 2015 ti120 with the side tenoning table and decent looking air clamp setup that just went on machinerymax for 6k. [email protected]> wrote:

Tom, Thanks for the details. That is a great setup. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Tom, I agree that your set up is about 3 levels above the F7. A side mount tenoning table, if you have the space, is pick of the coping litter. The spindle bearings on the T130 were lightened up in

Hi Imran, My TF-130 came out to be ~$30k. The TL Pro-10 package alone is ~$11k. Other options I included were: -- TL Pro-10 package, which includes the side-mount tenoning table, cast iron in-feed

Hi Tom, How much did your TF-130 run with your configuration? Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

David Kumm, Sound like you're pretty well set up, but if you were to consolidate down to a single machine I can share that I've been very happy with my TF-130. -- I ordered mine with the TL Pro-10

I'd offer 5500. If he takes it, contact me and I'll loan you the 3/4" spindle to finish your doors, just pay shipping . As to the SCM, Minimax, I'd look at the motors before upgrading. My only

In 2021 I purchased a 2019 F700Z that was essentially never used with a Felder 4 wheel feeder for $7500 plus freight. Your opportunity sounds expensive but I have not been watching prices. As a side

I ordered the 3/4 spindle when I bought my KF700 but after using larger 30 mm shaper I would never use the 3/4. What a difference. Sent from Philip Davidson -- Philip davidsonukuleles.com

I owned an older RL160 (2018?) and my starting capacitor died. Unfortunately you have to cut into the machine (yup) to access that area so I added some sheet metal for a cover where the cutout was

Just to clarify fully, the owner is asking $6500 for the machine ( https://www.facebook.com/marketplace/item/1054183152376024/ ). I'm budgeting about $1500 on top of that for freight since I need

Hi Kory, Welcome to the forum. I don't have any direct experience on the older F7 machines so I can't comment there. I do have a contemporary KF700, which is a saw/shaper with the F700 shaper guts

I have a 1998 F7 with 39" sliding table. Pre Covid and pre inflation, I figured it was worth about 4500-5000 with four wheel feeder and three spindles. 8k still seems a little rich but my experience

Gary my RL-160 was built in 2004 so there could be some differences with yours. The ladder frames that hold the filters do not come out on my machine unless you remove the entire upper unit with the

Hi Gerry, I can’t trust my memory and maybe RL160 is different but I don’t recall having to remove the brush frame on RL125 to replace the filter. Or maybe you are doing this for saddique

I have the opportunity to pick up a lightly used, older (1998) 10HP F7 with feeder for likely around $8k including freight I'm weighing against a new 10HP F700 or a 10HP SCM Minimax T55ES, which would

Ehrenwald@...

hello ed, what is your personal email address? best, h hlund 312.519.4848