开云体育

Hi John, Congrats on the new machine. I was in line to get the Kappa 450 x after initially ordering a Kappa 400. But due to pricing changes and complications in my time line I've actually ended up

Hi Ron, I have a FB610 and had a look at my fence. The set screws only seem to allow alignment of the fence to be parallel to the blade (or adjust the fence for drift). However, I believe that the

David, my wife calls me a “gadget guy” because I love gadgets and gizmos. I will be happy to share experiences with this system as I figure it out. The PCS is “only” $7,500, not $10,000, by

You may need different backing plates. I have Aigner fence plates ordered with my 2009 KF700SP and I had to get different backing plates to fit the plates to a 2017 700 series shaper.

Well, this should be easy. REALLY easy. Release the 230 hood clamps, slide old fences off, slide on new fences, smile and get back to work. Wrong. I can get the fences to the point of sitting flat on

Analog Felder DIO all but one steel case $55 each shipping included contact off the fog Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell

?I have 10 high speed steel 310 6-2 hole 310 Older style 4 - carbon steel all in nice shape looks like 1 edge new 2 hole new 130.00 takes all shipping us included in USA Pay Pal only Contact off fog

Post some picture of this knuckle. I don't know where the four set screws you mention are located, but on my rip fence for the saw which has a similar casting, you can adjust two set screws on the

The milled surfaces that the fence gets fixed to is not milled square relative to the surface that rests on the flat bar. I contend that this is the critical relationship that is not being maintained

The following items have been added to the Files area of the [email protected] group. * /For Sale/FOG_CF741S_for sale.pdf (

Hi Mike,? Thanks for the offer. Really appreciate it.

Thanks, I initially placed it reversed, this is why I couldn’t move the swing away, after swapping the latching plate I am now able to swing away the decide.

Yes. That’s the latching mechanism on-ramp. It brings a sagging swing-away coupling component up to the level required for the Kipp locking levers to align and pull the feeder securely against the

One more questions about the swing away. The small plate on the bottom is oriented in the right way?

Yea, I have the complete PCS PDF manual, and have read it. It strikes me as a potentially temperamental system that could easily frustrate people into turning it off or ignoring it, thus defeating the

This table is in the PCS manual. -- John Hinman Boise ID Kappa 450X and A941

This table is in the Kappa 450 manual. It does not address the blade versus table top, but does address the max diameter versus scoring blade. -- John Hinman Boise ID Kappa 450X and A941

By the way, the Kappa 450 will accept a 400 mm blade but will not retract it below the table top. The PCS displays a warning if the larger blade is mounted. This fact is not clearly stated in sales

A couple more points: This sounds suspicions to me. The PP has balanced outputs, and while it’s always a good idea to ensure the 3rd (manufactured) leg is not part of the circuitry used to power the