开云体育

Sounds like the brake board might need some adjustment. I will look for some documentation and get back to you. There are two pots to adjust, and it only takes the slightest tweek to make a

Reading through the comments on this thread, its really interesting to hear that some people are still finding lifting the feeder a bit of a chore even with the gas strut assisted bracket. I just got

Maybe slightly off topic, but wondering if the members would be willing to share what gear they use to shoot shop videos? Especially if you self-shoot without an assistant. Are you using a phone?

As you get older flipping the feeder up is more of a chore. I use a nylon strap around the feeder and a small chain hoist to raise or lower it, no risk of an injury to myself or the feeder. Regards,

Philip, Carpenter bees are a real pest. They do love redwood. Glad it worked out for you in the end. Tom Ruth

I have? standard PF with Vario4 on KF700. In 20+ yrs I believe couple of times the joints were not as tight as they needed to be while I was tilting. So I suggest locking the joint with memo pin

My friend was gracious enough to run the full 2016 BGHM document through Google Translate, I've uploaded to the FOG Files section here:

Thanks for the update! I was watching this closely as I really like the smart stand features but didn’t know if it would work with the Felder tilt away bracket. Seems like an easy fix. Well done.

OK, my plan worked. I was able to fabricate a 5/8" thick piece of steel to insert between the lift assist bracket and the tilting mount. That provided just enough room to move the smart stand base so

?What a pain to install the short hose for under the spindle dust collection on KF700. I did spend some time to find 80 mm hose but did not find much other than Felder and McMaster Carr. I went with

Many thanks for mentioning this on the Creek recently Joe, Never came across this, though the UK HSE stuff mentioned aplenty, with thanks also to Dave for the translation. Must look up Guido Henn to

Google Translate is your friend with these books.? The DVD that comes with them is helpful also.

Philip, It would be startling if a bee flew out while I was cutting wood. Took the time today to fix the bandsaw cable after the rabbit incident. I decided to swap cables so the power lines are

On 30 Oct 2024 15:35, "Joe Calhoon via groups.io" <joecalhoon@...> wrote: If you are interested in shaper, sliding table saw and other stationary machines Guido Henn has several good

Alex, I documented the weight difference between weights of standard stand (SG13) and SS in this post. Differences is 47 lbs. Re: Comatic DC40 power feeder stand arm length groups.io Imran Malik

Tom, Patrick, Imran and Andy, Thanks for the prompt reply. I reached out to Kyle at Shop Gear to see if he had a solution. No luck there. Tom's solution will certainly work. I just can't bring myself

The BGHM books are the best safety manuals. A lot better than the British HSE. They give the books out free at Fenester Bau. I did not see their booth this year. If you are interested in shaper,

I have the dc40 with the regular stand and a gas strut assist. The gas strut really only helps you on the lower half of the swing/arc. Once you reach a certain point, it is all on you. It isnt like im

Hi Andy, No worries, yeah the weight of the Smart Stand is such that, even with the gas strut, it feels like you're lifting the full weight of the stand, I can't imagine trying it without the gas

Hi Laurie, Not sure if you are interested in trouble shooting. It is hard to guide people remotely and many times requires 2 people. So I suggest you replace K1. From schematic it appears that your