开云体育

I looked and didn't find one. Sent: Friday, September 6, 2024 7:48 PM To: [email protected] Subject: Re: [FOG] A3-41 Parts Diagrams /g/felderownersgroup/files/Manuals%20

/g/felderownersgroup/files/Manuals%20&%20Drawings The files section of this forum has numerous manuals you can look at.....

My C3-31 came with english operator's and setup manuals, but the parts diagram legends are all in german. The parts and circuit diagrams themselves are decent, my german is not. I picked up a used

When you buy a new Hammer product, does it come with parts diagrams and/or exploded views of any kind?

Little backlash should not be a problem you see a little room for the screw to turn. You’re always adjusting. your final position against the thread or up so little loose would be better than too

The nut is NANA (Not Available in North America). I intend to order one "just in case," but it will take a while to get here.

Probably a stupid question, but why don’t you just replace the parts from Felder? Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell

Coming back to this issue for closure... I raised the table and removed the UHMW nut (58). The nut appears to be cross-threaded for about 1/4 of its length. This would normally be difficult to do with

I have the same fence as you, Jacques. Thanks for the pictures. It looks like you had to space it out even farther. I had some issues with the sheet metal from the table sticking out too far.

Jeff, Your previous message does not mention whether the fence you have uses the same approach as what is on my machine. I am nevertheless sending you a couple of photos showing the parts on my

I think I figured it out, but confirmation would make me feel a bit better. I'm sure I'm overthinking this, but I just want it to be correct. I was able to get the fence aligned this morning so I

Hello Jeff, Is this what you are looking for? This is this diagram that accompanied my B3, equipped with the round bar. Regards, Jacques

I did a quick look at the documentation that I have and couldn't find anything.? Which view are you mainly looking for?

Anyone have an exploded view of how the bar for the rip fence attaches to the machine? I'm specifically interested in the cast iron top area.

Thank you Imran. I will repost below with part numbers from your diagram. While inspecting the machine, I noticed the angle/tilt wheel is very difficult to turn. From the zero position, it starts

Hi Thomas, I did have a tip on this mechanism in my writeup. See top of page 10. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share Sent: Thursday, August 29, 2024 11:59 AM To:

Hi Thomas, Congrats on the machine. The blade tilt mechanism is silky smooth on my saw. It is easier to tilt as the motor weight is falling and slightly harder to bring it back to 90. Still, I think I

Thanks to generous help from a couple of FOG members, I recently purchased a 2005 K975. While inspecting the machine, I noticed the angle/tilt wheel is very difficult to turn. From the zero position,

Hi Jim, Pics did not come thru…. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Hi, Imran. Here are photos of the electrical panel, autostart box, and control panel. The capacitors are located behind the control panel and seemingly must be accessed from above by removing the