开云体育

Reporting back on the K2 powerdriver. It is really nice to be able to dial in the angle/height electronically, however I do have an issue with small height increments. Instead of raising the blade by

Jeff, I have received manuals from Felder for at least 2 used machines. I prefer a soft copy as it is accessible on my phone and computer. Manuals stay in a safe place but I do pull them out when

I bought it used so no salesperson. I did ask the tech I'd been emailing back and forth with, but it was towards the end of the day so not sure I'll hear anything back until next week. Sent: Friday,

Try Google Translate. It is amazing.

Imran Thanks for the tip, but unfortunately the C3 jointer tables are nothing like the A3-41. Appreciate the thought though. Sent: Friday, September 6, 2024 8:46 PM To: [email protected]

Sold, Thanks for the kind words! PK

Jeff, There is C3-31 (full combo) in the files section which may give you some idea. I suggest that you ask you Felder sales person to provide you with a copy. He/She will send you a link to download.

I looked and didn't find one. Sent: Friday, September 6, 2024 7:48 PM To: [email protected] Subject: Re: [FOG] A3-41 Parts Diagrams /g/felderownersgroup/files/Manuals%20

/g/felderownersgroup/files/Manuals%20&%20Drawings The files section of this forum has numerous manuals you can look at.....

My C3-31 came with english operator's and setup manuals, but the parts diagram legends are all in german. The parts and circuit diagrams themselves are decent, my german is not. I picked up a used

When you buy a new Hammer product, does it come with parts diagrams and/or exploded views of any kind?

Little backlash should not be a problem you see a little room for the screw to turn. You’re always adjusting. your final position against the thread or up so little loose would be better than too

The nut is NANA (Not Available in North America). I intend to order one "just in case," but it will take a while to get here.

Probably a stupid question, but why don’t you just replace the parts from Felder? Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell

Coming back to this issue for closure... I raised the table and removed the UHMW nut (58). The nut appears to be cross-threaded for about 1/4 of its length. This would normally be difficult to do with

I have the same fence as you, Jacques. Thanks for the pictures. It looks like you had to space it out even farther. I had some issues with the sheet metal from the table sticking out too far.

Jeff, Your previous message does not mention whether the fence you have uses the same approach as what is on my machine. I am nevertheless sending you a couple of photos showing the parts on my

I think I figured it out, but confirmation would make me feel a bit better. I'm sure I'm overthinking this, but I just want it to be correct. I was able to get the fence aligned this morning so I

Hello Jeff, Is this what you are looking for? This is this diagram that accompanied my B3, equipped with the round bar. Regards, Jacques

I did a quick look at the documentation that I have and couldn't find anything.? Which view are you mainly looking for?