开云体育

I'll try to snag a few photos when I get home tonight and see if I can post them. That being said, there is a German video from AKE https://www.youtube.com/watch?v=JBkdWr5yJfY here that @ 2:28 you can

I have a bunch of defective electronic equipment out of Felder machines, and some repair bills that refute Mr. Dingus’ claim that "The high leg's position does not immediately cause any problems

Here's the first of numerous machines I'm selling. https://woodweb.com/exchanges/machinery/posts/547771.html Time to recover some space to work more efficiently. Marlowe McGraw

Can anyone take a close-up picture on some of the teeth of these diamond type blades? THEORY:? I am thinking that it's not the kerf size that is causing your saw mark problems.? I think the size of

As I had one response from Felder’s tech support and a different response from the sales rep, I asked Mr. Dingus for clarification. His response is below. Note that my question for him was in

Awesome info. Thanks. I purchased the AKE blade with the Felder specs at 300mm 2.4 kerf. they have a 2.0 kerf 300mm blade that I felt might be too thin and likely have some degree of deflection.

The contractors I supply Millwork to build as Brian describes. Usually 1/4” ply attached to the walls then just lineal material we supply for the stiles and rails with butt joints at the corners. If

There is conventions... Geen fotobeschrijving beschikbaar. ... but there seems to be no strict adherence (from the Felder factory) for phases and there colors, luckily they do agree on Neutral (N,

Marshall, in all the wainscoting I have seen, and personally built generally you put your sub straight over the entire wall; stiles and rails are just rectangular (cross section) then a molding with

Few more from 30’s martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com instagram.com/maccampshure/

Ideas Snap shots from a series of hard bound books I have this one is from 30’s I have 3 different vintage books from 30’s back to 1890 for sale $125 .00 each Contact me off fog if interested.

Marshall, I think you are talking about making the cope and stick to allow you to insert a panel (glass typically) from the back? The attached infinity cutter set has that option. Jason Holtz J. Holtz

This is not answering your question but may give you some ideas.

You might have to run the profile separately and do jack miters. Then you could rabbet the back. Or just run your shaper cutters and cut the back part of the groove off. All more steps than a

I know how to do a few things but am certainly not a professional thus I am a bit confused as to how to proceed and have found little help online as to what I need to accomplish what I want. ?Any

Hi Ron, Typically there is a start (usually larger capacitance) and a run capacitor. Electrolytic capacitors are built with two foil strips (+ & -) with welded terminals which are separated by another

Liz is awesome, she is my rep. [email protected]> wrote:

The planner motor in my Minimax cu300 was working fine but when I attempted to restart after using it for a while it ?just hummed. The capacitor had a huge hole burnt through it. After replacing the

This may help explain: https://youtu.be/xacdDrylrek David Best - via mobile phone

A capacitor on my surfacing motor had a hole burnt through it the size of a 50 cent piece. I was planning some boards turned it off for around a half hour and when I attempted to restart it, it just