开云体育

Looking to add shaper tools for kitchen, vanity doors and drawer profiles.? I have a Felder KF7X with shaper plus 1-1/4 and 30mm spindles.? Also have router spindle. Simple, clean profiles is what

I wouldn't use the Ballistol, a bunch of us tried it when we found out Felder suggested it and I know my results were terrible. Best solution for me is a paper towel with mineral spirits on it and

Thanks for the heads up on that Mariusz, I ended up just using a vacuum and rag anyways. And yes, we can get Ballistol here in the States. I got everything cleaned up, but that didn't fully solve the

Greg, I’m not positive and I’m not near my machine to check it, but I believe there might be a sticker on the lower part of the sliding table that indicates that compressed air should not be used

Hi Richard, Best to post some photos of the fence without the extrusion on it, Felder has changed parts over the years and that way we can make accurate suggestions.? Brian

Rich, The two screws on the casting are to be used to set the rip fence square with the cast iron top, not to set it parallel to the blade. There should be a toe out of 0.002 to 0.004” set away

My suspicion is that you all are on the right track with something being obstructed by dust, my dust collector filters had become clogged with fine dust. I spent a couple hours doing a full tear down

That's great news PK. I guess you caught someone on a good day. I've had exactly the opposite experience with SCM on my wide belt. Jason Holtz J. Holtz Furniture 3307 Snelling Ave. South Minneapolis,

David, Greg said it powers up but shuts down as soon as he moves the slider so the first thing I would look for would be related to the slider. You are correct that the micro switches, especially one

Mariusz is certainly correct that it could be the remote stop circuit at the end of the sliding table if you have that option. But that’s not all that could be causing this. My Kappa 400 (which is

Hey Brian, thanks a lot for your response. Its fairly straight without clamping. Do you have any guidance on how to make these adjustments? I have tried to adjust the aluminium bar and also the 90

Hi Greg, I agree with Mariusz if you have a stop switch on the end of the slider. Only the stop switch uses the rails for carrying the current. It has also been reported here that this circuit is

Greg, This is a long shot as my saw does not have on and off switches on the slider, but the reason I chose not to have them was just this issue, if it is indeed what I think it is. If I’m not

Hi All, I’ve had an odd problem pop up today with my K940S slider. The saw is shutting itself off, seemingly spontaneously. Initially it happened a couple of times this morning when I was starting

Chris Rozycki

Netanel, Not far enough along yet. Just got it off the truck yesterday. Got a 26’ box truck with a lift gate and an 94” clear opening. Crate which was substantially damaged by the shipper, was

I still appreciate my connection to Felder and Carl, but... I started a purchase journey of a used 2011 Casadei Libra 10 37" single head wide belt sander about a year ago (basically identical to the

Glad to hear you got your machine. Did you had to adjust the machine or it came calibrated?

I receive my FS41ES just yesterday and went with SCM for all the reasons you mentioned! Kind regards, Brian D. Milidrag Cell 248.7

I buy them from Tersa Knives TersaKnives Inc. tersaknives.com Here is their recommendation based upon wood species. Wood_Types_list PDF Document · 70 KB I got the machine with HSS and am currently