开云体育

Couple questions - are you removing the whole edge on both the cope cut and the profiling cut? It looks like from the pictures your tongue is way short. Hard to see in the picture. Does the cope

I’ll hazard a few guesses: Your spindle is not perpendicular to the cast iron top and you don’t realize it. Or your coping sled is angled downward at the spindle end due to an excessively high

I am confused by a problem I'm running into. I am setting up the KF700 with a set of Amana cope and stile cutters. I have the stile cutter on the bottom and the cope on top with about 40mm of spacers

Hi Steve, I assume you are asking for the 45 deg as the blade can be raised for 90 deg kerf. I was cutting a scarf joint on 9’ long walnut boards that were 1’ wide. One piece had to be cut upside

Imran, how did you make the cut for the scoring blade? Steve

Steve, Well done. So I use 2, one for straight cuts and the other, that allows the blade to tilt all the way to 45 deg. Few months ago I realized that, on my saw, there is no way to make the angled

Nice Job! Bill B

Feeling a bit impatient as I destroyed my throat plate a few days ago, I went ahead and modeled up the ZCI and cut a few on the Shapeoko. I made one from 9mm baltic birch and another from a scrap of

Great thread, I've got a bunch of bits ordered, I'll post pics when I'm done!

I have a K540S, so I may be able to help. Have you tried preloading the adjustment handle more than the factory setting? Mine was a bit loose when I got it.

Michael, Router spindle was on sale not long ago. It was almost a 1/3 off. May want to check Felder Eshop if it is still on sale. Now there are 2 models for recent machines and you will pick one for

This topic was discussed in 2019. If you search "KF700 Spindle Change", you can find the conversation. Here below was my response in the thread. Now, I have the Incra router lift with Porter-Cable

Wow, this group is GREAT. I’ve been on about a month and I’m learning so much. Thank you to everyone that offers up their advice. I’m a hobby woodworker that is finally finding the time to

Hi David, This thread reminded me that I have one of these millions that you produced. Used once and then I got router spindle. I need to find it and put it up for sale. I did mention it to Bob in a

Bob, have you seen the attached? It’s been in the archives for 20+ years. I sold millions of ‘em. LOL. Today, I would use a cordless router. David Best DBestWorkshop@...

Bob, I have posted router-table-in-slider pics before, so this is for those who have not seen them. Note that my machine is a short stop (1250mm) Hammer K3, and there are differences in the respective

“And if you just want to shave half a blade thickness off an edge to clean things up, shit's gonna go everywhere.” No support on either side of the blade Is not good for the blade. Best mac,,

I know that Jaon Bents ( https://www.youtube.com/@bentswoodworking ) was at Felder recently to shot a calibration video for the Hammer K3/A3

Hi Tom, Thanks! That actually is helpful. Apparently I was trying to adjust the height by adjusting both sides of the outfeed bed instead of just getting it level front to back, and THEN adjusting the

I am confused by the air slot feature.? The work piece being cut has effectively zero clearance and air flow is limited by the kerf in the piece and by the tooth gullet carrying waste.? Saw teeth