Bob, I have posted router-table-in-slider pics before, so this is for those who have not seen them. Note that my machine is a short stop (1250mm) Hammer K3, and there are differences in the respective designs. Nevertheless, there may be some ideas here for you.
The router table lies in a panel added to the outfeed. This is made from an off-cut from a kitchen bench. This is compressed (hard) and waterproof (no movement or expansion).?
This is the space available ...
And this is the build ..
Originally the fence (which I built) ran in its own track. Later I connected it to the rip fence, where it takes advantage of the micro adjuster and digital gauge ...
The fence just sides on-and-off as needed.
There is dust collection from both below- and above the table ...
The hose comes from Festool ...
The other useful item is a flip-up Wixey digital depth gauge. This is on the left front of the table ...
When not in use, the router table fence hangs above the slider ...
Details of the build are here:??
Hope this helps.
Regards from Perth
Derek
