开云体育

I don't mean to speak for David, but last I spoke to him he was no longer making them. ?I'd also be very interested in buying one if someone with machining skills decided to fabricate some. -Joe

I would also be interested in purchasing. Thanks

I would be interested in purchasing it as well. Elwin

According to a comment on this post, Meyer is using the 30W version of the vibrator motor. https://www.instagram.com/p/CwZ8n_PA9RS/

Hi Phil, I assume the motor has a contactor. In general a contactor can be placed at a distance from the motor. It may actually be not too much work if the 3 phase is going to be routed from inside of

I would also be interested in purchasing this from you. I'm in the UK, is that a problem? Thanks

David Best, Are your short crosscut fence kits still available? A long while back I was on “the list” if you were ever planning to do another run of these. I’m close enough to you to pick up in

Hi Phil, At the back of the machine there's a pipe that seats onto a gasket in between the two bags when you lift the bag bin into place. This diverts suction to the bottom of the bin to hold the bags

The Felder short crosscut fence is a flawed design. Lots more information on it here: Fixing Design Flaw with Felder Short Crosscut Fence flic.kr David Best - via mobile phone

Apologies if this topic has been posted before but I can't find any info on it. Are there any tips and/ or tricks for setting up the short crosscut fence for the first time. It seems incredibly fiddly

17 years I've had this RL160 and it's only recently started to suck up the bags again.? Thinking one or both may have been holed, I changed the bags for new ones but it has happened again. I recall

I have just purchased a 4.5kw 3 phase unit which I want to position outside the shed under an awning. It has a push to start button attached to the motor. For obvious reasons I want to be able to

I would do that with my block plane or Mirka sander. Jason Holtz J. Holtz Furniture 3307 Snelling Ave. South Minneapolis, MN 55406 612.432.2765

Imran, Both Brian and Dan gave you approaches that work well and are simple to implement. For my part, I always like to complicate things a bit ?: I have cut chamfers on my spindle using a single

Thanks for the share, I will be picking up one of those vibrators and some phenolic to make my own!

This would be easy enough to do by tilting the blade on your slider and bringing your rip fence in as a stop with fence pulled back just before the blade. I cut all my 45s that way on the slider.

Wright are still avaliable had and purchased for my gone 116. Maybe Black Diamond. Dust collection on my Rapid is quite good. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi

I needed that fix. My 217 is beautiful but pales next to your Y30. I almost had Ben Rock restore a machine for me years ago and regret that I didn't pursue it. You will like the Wright guides. The

You "need" more pictures? ?LOL ... ?OK What I discovered was that the way to adjust the lower guide was to remove the left guide using the easy to see hex bolt. ?With that removed, I could easily

I do a lot of chamfers like that in chip out prone material and have found saw blades coming down across the material to be the safest way. Brian Lamb blamb11@... www.lambtoolworks.com