开云体育

Looking at your level readings, I would have no problem working out the twist in your table in less than 30 minutes by altering the relative heights of the two temple bolts. You should not have to

Normally, it’s easy to alter the elevation lever to provide a wider and certainly different position for the top and bottom range of the outfeed table. It requires repositioning the threaded shaft

I realize that probably no one in this forum owns a miter saw, but at these price points, this might be a nice way to set stop block.

Hi Larry, I just received this add from Harvey that is selling the AH-3T for $149 instead of $229 today only. It's last day of the year sale. Bill

Hello Andrew, Happy New Year! I own the AD741, but I assume the AD941 to be very similar in design, requiring similar setup procedures. David Best's document is amazing and details every aspect of the

Unfortunately, I have been right where you are. I have a couple of resources that will probably help diagnose this further. The first is a Jointer Survival Guide that goes through the process of

I would sugest never adjusting the hinge side at cutterhead at out-feed. With straight knife or tersa cutter body should be about 8/10 mm under lip edge. Side to side few tenths I don’t know about

Does anyone know the procedure to get the AD941 outfeed table parallel to the cutterhead and at the correct height? ?Should I be adjusting the height on the hinge (rear) side, or only with the two

I would also be interested in several for my k700 if you feel up to making some. John Adank jnadank@...

I have nothing good to say about the Felder clamp, except that I no longer have it. I use Milescraft and Kreg clamps. The Milescraft with the base kit fits a KF700 without modification. I use it as a

I would also like an insert for my K700S, please add me to your list. Thanks, Chris

DAN, i WOULD ALSO LIKE TO PURCHASE SOME ZERO INSERTS FOR MY K700S. Please add me to your customer list when you start building them again. Best Regards, *Scott Glaser* *6627 Dolan Falls* *Flower

Jonathan, Thanks for the picture. It looks like I'll need to grind off a couple threads off the hold-down bolt and it will fit. My solution won't be quite as elegant as yours - I tend to use what's

I haven't replaced with anything else bigger yet, though it does use a lot of air, it's easy to flip open a valve by the saw when I notice a performance drop cleaning up at end of the day. It comes

Does the GT13 shaker work well, Brett?

Hi William, Thanks for the link. The Bridge City version looks pretty nice...think I'll jump on YouTube and see if I can find any videos. Larry

Installed this before the official accessory existed....Amazon buy,pneumatic vibratory mechanism GT13. I consider it necessary equipment, esp. if you overload your cyclone ever or you don't have a

Since there seem to be more than a few Clearvue owners on the list.... any of you have the shaker? Does it work well? -Bob

Dan, I’m also interested in zero clearance inserts. Please let me know if you have any for sale. Thanks!!! Happy Day!!! Randall Sent from my iPad Pro (12.9 inch)

Hi Larry, Bridge City Tools sells a less expensive version. I have not tried this but it is very similar to the design of the Harvey version and only $49.99.