开云体育

Bill, I drilled a pilot hole into the reader and fixed it with a small self tapping screw. David Davies, that fancy piece of antique English furniture was from a client I was making the Kitchen for

To add anything that might be helpful, I am currently in initial installation trials of a Oneida Supercell Turbo for a specific situation. It top dead heads in the 90+ in.H2O range (WOW!), the

William, I really like how that Harvey Compass looks but, man, that is not cheap! I have worked long and hard my entire life and now in my late 60's, I have the disposable income to not bat an eye at

You have to be careful on your main duct size. ?I considered this in my setup. ?If you look at my pictures, I have a very short section from the collector where the main is 8” duct (right before

Thank you Joe, When I had my Sawstop, the overarm dust collector hose was 2" or something like that and did a poor job,especially MDF. I made my own overblade dust cover from 3/8" plexiglass,

Pierre: I will send you a private message and we will set something up. J.

Hi to a fellow engineer ? My saw has the riving knife hood which I heavily modified to increase airflow but it still doesn’t get all the dust, especially if cutting a small amount off so the

Hi Joe, I am new to the forum and so appreciate the technical input. I am a severe asthmatic and good/great dust collection is of paramount importance to me. Also my wife hates the dust if it

Hi Bill, The T-slot version (AH-3T) fits my SCM slider with no modifications.?

My ceiling is 9’ 2”. ?The Clearvue Pentz EF-5 is 106’ (or 102” with shorter 20 gallon drum). ? I literally have about 4” between the motor and the ceiling: You can get a slightly shorter

jJoe's paper is very good and worth reading. Airflow at higher pressure is the key. Many wood shop collectors use lower pressure impellers that move a lot of air with large machines ( think Wide

Bills Clear View design is a more efficient cyclone than Oneida. If you could couple Oneida’s controller with a Clear View cyclone it would likely be a bit better than the Oneida.

The science of dust collection falls into the mechanical engineering field called fluid dynamics. As an engineer I studied fluid dynamics in college and sadly much of the “wisdom” on the internet

Yes, Bill Pentz has done a tremendous amount of research in the field of dust collection and the Clearview cyclone design was based off of Bills Specs. Most of the dust collectors sold do not capture

I got the clearvue max, I run 8" mains, 6" drops , 4" gates off the 6" drops. Works great. ?Get BlueMail for Android ?

Thanks Aaron. How high yur ceiling need to be to accommodate it? My shop ceiling goes from 8 to 12 ft, but I planned to install the dust collector towards the back which is 8ft.

Wow, super extensive. The more i read his stuff the more it convinces me that my setup need a big upgrade!

Hi Jacques. I am in Shefford QC, a bit far to come take a look, but maybe we could setup a quick facetime call if/when you have time.

Jonathan, Do you have an STI file for this that you'd be willing to share? Thank you, Steve

I have had an Oneida 3hp Super Dust Gorilla for the past 15 plus years.? It has been awesome and completely trouble free.? The suction is great and I added a dust bin sensor and a pressure gauge to