开云体育

I also installed a full GRIT Automation system on my Nordfab gates for my Felder A941 jointer, D951 Planer, FB710 Bandsaw as well as adding it to my SawStop ICS, Festool Kapex, and router table.?

Hi David, Thanks for clearing up that question. Slip fit makes perfect sense. Indeed, if I go the same route, three blast gates will be needed, with one acting as the master, controlled by the Grit

Alex, I use the quick connect fittings at the machine-side of the flex hose. It just slips on/off the dust extraction port flange. It’s a tight enough fit, that no magnet or other latching device is

Hi David, Thanks for the prompt reply. And thank you for the photo. It answers all but one or two questions. I have the opportunity to do just what you suggest. So my next question is how do you

Alex, as long as you’re reconfiguring your dust collection system, I would recommend you consider using a separate flex hose (with blast gate) for each end of the machine. You can see in the

Hello Everyone, I have an AD951 Jointer/Planer that I have been using with a very temporary dust collection setup. ?I have now installed NordFab dust collection to all of my machines. ?I have 7"

I got the same notice this morning. One really has to admire how this team has evolved a product that started out as a 3D conceptual design tool for the iPad. I look forward to beta testing it, and

Just got an email from Shapr3d.. they are adding parametric features with history based timeline this year. Will be interesting to see how this

I had plans to build a bandmill based on the excellent design by Matt Cremona.? ?The mill as design will cut 6 feet wide.? The plans were about a hundred dollars when I bought them.? Matt has

I received my Profil 45 Z with the Aigner Integral fence and high-speed spindle one month ago.? While I haven't used it yet I found the same lifting issue as you.? Moving the fence as far to the

I watched that video as well, stopped the vid, ran out to the C3, took off an endcap, same construction apparently as his K3.? Left a comment at YT, awesome idea. ;-) I have a couple of his ZCI's

Brian, for some weird reason I do recall a long time ago someone jerry rigging a block and tackle setup to help lift the shaper hood on the Profil 45. ?Easily ten or more years ago. I have the Profil

Just watched this vid from Ramon Valdez and thought there may be some interest in this storage idea he has for a very sneaky drawer in your slider: https://youtu.be/ud1j76-KBk0?t=660 That is of course

Brian, You’re right, just doesn’t seem right doing it the other way. Thx, Wade

Well tech isn’t quite right, the cast iron sits between #13 and #4, both spherical washers, #12 and #13 always go together on the same side. Other than that, the picture is what you want. Brian Lamb

? Hello FOG, A Felder Tech sent me this regarding the support bar hardware orientation install. A bit interesting to me. Didn’t see this being a possible layout. “Here's the schematic for your

I used to have an Oakley stroke sander with a 10' bed. Over 15' long overall. They are fantastic machines and very versatile, but I couldn't justify the real estate for the amount of use it got. I was

Joe, the finish off of your Kundig is pretty impressive...

Mac, I used a Samco lever stroke sander for 12 years before getting a WBS. A lot of feel and skill to run but the finish as good or better than my Kundig. Had a woman employee that mastered it better

I agree with Jason Saunders veneer is a good place to start martin/campshure/co/llc. mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@...