Re: AD941 installing fence support bar
|
? Hello FOG,
A Felder Tech sent me this regarding the support bar hardware orientation install. ?A bit interesting to me. ?Didn¡¯t see this being a possible layout.
¡°Here's the schematic for your machine. ? Look at the box enclosing the parts for the AD941. ?You can see the spacer is included in your machine. ?The cast iron would go between part numbers 12 and 13. ?I don't see the large washers anywhere. ?Perhaps they are for a different machine that uses some of the same parts and they made a generic set up for a few machines to use almost the same hardware but they included all the parts for them all. ?I would follow the schematics for the AD941 machine to be sure you are correct.¡±
toggle quoted message
Show quoted text
On Jul 1, 2023, at 5:39 AM, andy.pickler@... wrote:
?I just received my AD941, and this is what I did (not that it is correct). I used the spacers to ensure a consistent distance for both the left and right attachment points, and I figured that would better ensure that the jointer fence was perpendicular to the cutterhead. I did not use the big washers on the backside but rather the two washers ("ball socket 1" and "ball socket 2") that have one side each that is concave/convex and fit effectively "inside" each other. <IMG_3444.jpeg> <IMG_3443.jpeg>
|
