开云体育

Hi Mike, I deal with a lot of vendors and there is no standard protocol. Amazon click, yes eBay click yes Some vendors require special arrangements and they all veri and have specific requirements .

Quinn Saw and Tool has been great to deal with https://quinnsaw.com/

I have a couple of Tenryu blades - I am not very happy with my rip blade. I think the tolerances are poor. I have an Amana that seems pretty good, although I did have a local shop retried it to a flat

Hi Mike There may be better options for getting good blades from known reputable suppliers, however.... One way to deal with overseas or suspect suppliers is (if you are prepared to risk the total

Told Wade, Will give them a call. Mike

FOG, Felder called me back! Holy crap they actually called me back! It’s a miracle! Anyways, they do sell leveling feet for the AD941, without having to buy the mobility kit. David Best is correct,

Mike, This is who I use for my blade needs. And you don’t need to give them all your personal info. Professional Saw Blades, Router Bits and Dado Sets ridgecarbidetool.com Thx, Wade

I'd like to buy a 28 tooth 300 mm od 30mm bore std kerf quality rip blade for my slider that is not made in china from a company that will send it to me if I give them my credit card over the phone.

I just used scrap wood to level the AD741, I will never move it in the garage. James

Hi Bill, I’m only simply going off of what the manual is indicating to do. But good question, maybe to preserve the performance of adjustability over time. I’m not really sure why they want it

Thank You David Best, So you’ve indicated there are no threaded holes, like there is on my K700S, so I’d have to pick up additional nuts and washers as you indicated on your Flickr pages. I’m

Wade, can you explain to me why a jointer planer needs to be level? I’m not getting it. I have an AD941, never bothered to level it and no issues. In fact I know it’s not level, my floor slants.

I simply put a tapered shim under one corner of mine to keep it from rocking. -- John Hinman Boise ID K700S and A941

This is what I have on all my Felder equipment: https://www.flickr.com/photos/davidpbest/albums/72157718814798961/ I would recommend the same but without the rubber pad if your floor has any slope,

? FOG, Has anyone, with an AD941, installed a set of leveling feet? Could you let me know what feet you used for this application. Felder has told me the machine can accept leveling feet, but they

Thank You Brian, I’ll ask about leveling feet, only because I do have some slop on my shop slab. Wade

Mike, I assume you know you can make several drawings from a single model as independent projects. That does quickly eat into the limit of “10 active projects” but it is one way to get around the

I don’t have a parts list for that machine, but suspect your pin might be more of an “anti-rock” pin than leveling. Three points make a plane, so you set the unit down and then drop the

"Who wouldn’t want a spring joint every time?" Joe

“ We can have it delivered tomorrow “. Mark Foster