开云体育

Yes Wade, I do... https://www.etsy.com/listing/1317660318/120mm-port-to-5-hose-adapter Bill [email protected]> wrote:

Bill, Do you have 120mm to 5” adapter by chance? Thx, Wade

Aaron, I've added a 120mm to 6" adapter to my shop. https://www.etsy.com/listing/1413717184/120mm-to-6-adapter Bill Bélanger [email protected]> wrote:

Thanks for that David. I have a 140mm to 6" adapter on my Etsy store. Bill [email protected]> wrote:

Nice work.? Looks like fun.?I see leaves on the trees.? Makes me hopeful.? I would like to be outside making saw dust too but worry if I set a tool down it would blow off the bench and disappear

You can see all the details of my dust extraction setup at this link. https://flic.kr/p/2gfsXWG The Dual 51 has a 140mm extraction port and I use two sections of 140mm ID flex hose. Nordfab supplied

After looking at David Best's pictures, I actually looked up the specs on the Felder machines.? The Felder 51/510 sized machines actually have a 140mm port (5.5"), so I would think you can clamp down

Is it better to reduce down to 5 beforehand?

David Best, So you use a 6” diameter dust collection hose for your dual 51, is the machines outlet 120mm? Thx, Wade

I would start by checking you start and run capacitors.? If the circuit trips after you let go of the start switch the issue is likely your run cap. Capacitors are typically the weak point in single

Going through the configurator on the Altendorf web site was quite interesting. There are a lot of options! I don’t know if the result is more like a sports car or a truck. -- John Hinman Boise

Hi Derek: A couple of questions below, all with thanks for taking the time to post. There’s a lot in your post for the forum! Cheers. * It is very nice to see Festo gear in your shop. I’m an

I bought my F45 a few months before the IWF show which no doubt were selling lower than I paid.? The base machine is $39k then you add in automation on rip, scoring features, digital fence (+$5k),

Hi all, having a issue on start up and looking for some help Machine is a 2008 KF700 single phase. This machine I only used as spindle moulder, I've owned it for approximately 2 years and have had no

Thanks David, I understand better the sentence "Could lead to more problems", so I cross fingers that the technician can fix the cast iron table to something acceptable. From a phone discussion, the

David I would like to get your Survival Guide; I have tried PM, but it did not work and I couldn’t find any contact info on your site, so I apologize for this new thread. Please let me know how I

In my experience, it’s a lot more friendly to have separate extractor input hoses for jointer and planer modes on a large combination J/P. I hate wrestling with a long unwieldy 6” hose. Far

No. This is the one I thought was not as clear as it could be. Just suggesting more thorough specifications. Remove ambiguity where possible, Go verbose,

Are you talking about this one David? https://www.etsy.com/listing/1356539645/80-mm-hose-union Bill B [email protected]> wrote:

Bill, I would also suggest you specify if a dimension is inside diameter (ID) or outside diameter (OD). I was looking at your 80 x 80mm connector wondering just that. I’m needing 80mm OD to OD for