No. ?This is the one I thought was not as clear as it could be. ?Just suggesting more thorough specifications. ?Remove ambiguity where possible, ?Go verbose, ?
David Best
DBestWorkshop@...
https://www.flickr.com/photos/davidpbest/collections/
https://www.youtube.com/@David_Best
toggle quoted message
Show quoted text
On Feb 27, 2023, at 9:22 PM, Bill Belanger <Bill@...> wrote:
Are you talking about this one David?
Bill B
On Mon, Feb 27, 2023 at 10:15 PM David P. Best via <dbestworkshop=
[email protected]> wrote:
Bill, I would also suggest you specify if a dimension is inside diameter (ID) or outside diameter (OD).? I was looking at your 80 x 80mm connector wondering just that.? I¡¯m needing 80mm OD to OD for a hose splice.?
David Best - via mobile phone?
On Feb 27, 2023, at 6:51 PM, Bill Belanger <Bill@...> wrote:
?
Great suggestion Brian! Thanks?
Bill B
You might want to add to your Etsy listings the sizes that the adapters fit. Say the rectangular, list it fits over a 30mm x 80mm port and fits a 4¡± hose on the outside on the round end. That way the customer can measure their machine and be sure they fit.
On Feb 27, 2023, at 6:05 PM, Bill Belanger <Bill@...> wrote:
I might have made one of those Richard. If you can measure the rectangular part of the port, I can check. Then whatever hose size you need for the round. Unless I¡¯m misunderstanding?something. Unfortunately I¡¯ve been making parts for folks and not documenting what machine ?they are for. My bad¡
Bill Bhe?
Since we're on the subject of Bill's store ... is there one of those rectangular to round dust ports available for a Hammer K3/B3? Original hose was lost and I have a makeshift thing in place, but I'd like to get something that captures a bit more dust in there.
David P. Best