开云体育

Retrofitting a DRO to the cross-cut fence is an interesting idea. I had no experience with DRO when I ordered my saw, so did not include that as an option. Since then I put a Wixey DRO on my

James, sorry thought you had a retrofit DRO. Kindest regards Jonathan Samways fineinteriorwoodwork.com richardmartinwindows.com

Imran, M503 or LP02 are not Siko manufactured units. James

Jonathan, I have Felder DRO on my crosscut fence. I am making the F&F jig with DRO, and will post photos after I am done. James wrote:

Hi James. Would you be prepared to post photos of your DRO set up on the crosscut fence? Kindest regards Jonathan Samways fineinteriorwoodwork.com richardmartinwindows.com

Hi James, I doubt very much that these are Siko manufactured units based upon the price. But at the same time if they work one is free to buy it. It is just not for me. Imran Malik

Imran, After watching the youtube video https://www.youtube.com/watch?v=NFOzEgkovtw&t=756s, I tried to find the DRO on AliExpress, was shocked to see the price, cause I recalled people mentioned here

James, $500 price was shared here from a reputable source in USA. Here is what I saved from a FOG email pre-pandemic: MA503/2-0001 - $579.40/ea MA504/1-0001 - $326.70/ea (alternate to above has

Hi Brandon, I have nothing but good things to say about the Alpine classes. If you’re new to the sliding table saw and shaper, then the “Advanced Joinery” class will give you a huge head start

Imran yes. Definitely think we should collaborate on crosscut fence DRO. stan

I'm going to buy a couple of these Chinese DRO's and have a play. I tried going the Italian DRO route, basically they don't answer there mail. Kindest regards Jonathan Samways fineinteriorwoodwork.com

I just attended Alpine in October. Having no prior experience with shapers I found this experience invaluable. Safety is emphasized every step of the way. Joe and Greg are great resources. I would

Actually mounting any DRO on the slider rip fence is a lot easier than mounting on the crosscut fence. Here below one buyer did it on his slider's rip fence. [image: Capture.JPG] James

Wade, I do not see why it cannot be adapted to any slider saw crosscut/rip fence. All the DROs work the same. If you have a milling machine or laser printer, it would be easy to make the housing for

Imran, What do you mean the new costs $500 ? What I see is C$84.31, which should be about US$62 based on the current exchange rate. [image: Capture.JPG] James

Hi Jonathan, I am thinking about looking into it next yr. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Okay. The new costs ~$500. I tried Ali Express once and not doing it again. Imran Malik https://www.facebook.com/groups/362481112015700/?ref=share

Any ideas on fitting a similar dro to outrigger crosscut fence? Kindest regards Jonathan Samways fineinteriorwoodwork.com richardmartinwindows.com

Lucky, I had Hydrovane before, and my current compressor is a 7.5kw silent piston compressor by Chicago pneumatics, I think I had it more than 5 years now. minimum maintenance needed. I didnt touch

James Zhu, Could the M503 DRO be adapted to a K700S rip fence? Thx, Wade