开云体育

Hello Michael, We have a 2003 CF741 with the short slider. ?Since we don't cut sheets of plywood very often, the shorter unit works quite well for us. All adjustments are manual crank with Felder

Bill, Not sure where you are on this project but I have gotten a bit serious on this mod for my K975. If Felder offers DRO on rip fence for your machine, the parts to mount sensor may be in your

I bought the short cross cut fence with my K700S, probably because it looked so familiar to the way a cabinet saw works. I found the same issues with maintaining square, and the big fence works well,

Michael, Welcome to the group.? Been there, done that, and without a tee shirt.? I had a 2004 model CF741SP configured similar (spiral cutterheads were not available then) to what you are

Welcome Michael! I have a 2007 CF741sp with power drive on the planer. Personally, I think that power drive on the shaper would be a great addition as one of the issues with shaper setup is accurate

Hi Michael! Congrats on the CF741SP, I'm sure you'll enjoy it. I have a 2020 KF700SP w/ 3200mm slider, 1500 outrigger, similar specs to your machine. In terms of Power Drive, I'd suggest Power Drive

Hi everyone, I’m new to the group, I am a hobbyist working in a one man shop, and finalizing an order for a CF741 SP, some of the options I got were 9ft slider, spiral cutter, 1500mm outrigger, Dado

David Best - via mobile phone

Thanks for the link to her web site! That was fascinating, particularly the descriptions of the wood. Regarding bandsaws, I have a 14” Delta. It was good when I got it, I suppose. I later had a shop

I have a souped up Delta 14? bandsaw and have made all my Maloof pieces off of it

In the Luthier world, a few names stand out for being the best of the best such as Kathy Wingert, Jim Olson, Kevin Ryan, Wayne Henderson, Kim Walker and a few others. ?The quality of their work is

Tom, I ordered mine in October of last year. It did end up needing to be custom as I had added an E-Stop and they didn't have any. I wasn't in dire need of it at the time either. Hopefully it'll be

David, Thank you for the lesson.? I watched your posted episode and learned new skills with Fusion 360, which I have been using for a few weeks to see if I want to switch to it from Sketchup.? So

Doug I bought a 20 yr old Agazzani 600 last yr, and a friend recently bought a Rapid 600 that is basically the same machine. I paid a little over 2300 for mine which is a 5 ho single phase. I think if

Thanks James. The different planes are a result of copying and moving the components of the middle assembly. Those are actions Fusion created based on the copy and paste new I used. Mike King Special

Thank you David and recover quickly! Mike King Special Consultant NERA Economic Consulting +1 303 618-4915

Hi Jared! I ordered my FB710 on February 9th 2022 and was advised to expect delivery in September 2022. I ordered mine with the 7.5hp motor, which motor did you select? I have another machine

Mike, I went through the drawing errors that you mentioned.? I attached a picture of the first.? It appears that you are executing the Combine Command with components on two different planes.? The

When is delivery of your saw Tom? I ordered the same and mine was originally scheduled to show up in July 2022. I haven’t heard any status in quite awhile though so I’m not holding my breath.

David, Thank you so much for taking the time to make these videos! I've been hoping to find exactly what you're making for some time. I’m really looking forward to having a resource that targets the