开云体育

Ed, Start a service ticket with Felder. The tech will guide you to turn the calibration potentiometer so that the blade stops in about 6-8 Sec. If you use a dado, you may want to ask if the

Speaking of lost braking, I just got my single phase K700 a few months ago. It seems to run well but it takes a long time to come to a stop. I never noticed this before on any other saw I owned. Is

Fred, I use Waxlit. My moulder has a waxlit dispenser with a wick that’s in the table. On the planer I just keep a spray bottle. I want to try it as Mac describes on the jointer and shaper. It works

It is the same stuff. What is a moulder dispenser? [email protected]> wrote:

Well I have couple gallons that we used with Moulder dispenser. Hope it’s what your talking about. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

Mac, are you using the paste wax or liquid form? [email protected]> wrote: _____________________ Fred Rossi 617.905.

That what I do works,fine I use power buffer. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

All: Has anyone ever used the sliding agent Waxilit? If so, what is the best way to apply the liquid form? Spray bottle? Squeeze bottle? Dampened rag? Do you apply, rub and buff off like you do with

I did what Brian suggested and have been satisfied. Jarrett

Only few hrs left and it is 3 phase. Doubt it will remain at $500 but you never know. https://dickensheet.bidwrangler.com/ui/auctions/82816/8570096 Imran

I am looking to purchase a single phase shaper, perhaps an F3. ?Thanks.

If your exhausting out side you don’t need any filter! Mac,, martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

If your Exhausting martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

I use 3M N95 paper masks. They have are comfortable, and from what I read about industrial hygiene when I began woodworking they are adequate even in very dusty conditions. Once I starts sawing or

I use the Trend Air Stealth. Very comfortable. The Miller LPR-100 is also a nice comfortable compact mask. I have both but prefer the Trend Air Stealth. John Adank

Hello Philip - I am also a DIY'er hobbyist in a home garage shop.? Depending upon the task, I use: - DemeTech N95 mask if I'm not doing a dust-intensive operation.? I would recommend the true N95

Hi All I am a home hobbyist and was wondering what people were using for personal dust masks. Have been looking at various options and don't want anything too cumbersome but of course want to

I have used a single VFD on two machines, where one was used often and the other occassionally.? ?VFD to twist lock plug,? unplug one and plug in the other.? ?The usual caveat about NEVER

In 2009 I upgraded the electronics in my 2000 CF731p single phase combo machine. Mark at Felder sent a kit to upgrade the circuit board based electronics to modular electronics. He walked me

Bob, I am curious about the electrical design of your machine. From your description it seems that a motherboard is used and Felder is not able to troubleshoot, thus a full replacement is