开云体育

Hi there Felder group, My first post here to the group, but I've been enjoying reading the conversations since I joined a few months ago. I have a Felder Comfort Rolling Carriage for sale, in almost

Paul, I know exactly what you mean. I got sick of the gap between the planer and saw table and the poor, to me, operation of the rip fence. I used a length of 40/80 slotted aluminium extrusion clamped

Years ago my father was on a ladder on a lower roof working on the second story and the ladder slid out from under him. This was in the days before cell phones. In the fall his leg was tangled in the

Jason, thanks for this. I am guilty too often of doing things while alone in the shop that would be better with help. As I get older and weaker I am better as having my son in law come over to lend a

Thanks Jason for sharing – that’s very sobering. Best wishes to your friend for a full and speedy recovery. One thing I would add to this discussion – in the commercial world, there are

That’s a good reminder, thanks Jason. When Apple came out with their series 4 Apple Watch with fall detection both my wife and I got them and had my 90+ Yr old parents buy them as well. If the watch

Acharya, both motors are acting the same way? That in itself is a little wierd although if MM uses Fimec motors I'm not complietely surprised. Are the motor single or three phase and what are the

Best wishes to your friend, Jason. I’ve had my share of accidents on the farm, and our neighbor is now partially paralyzed after such an accident. The working alone deal is often part of the

Jason, I pray your mate comes out of it fully recovered and as soon as possible. I learned this lesson when i was on the roof during constructing the addition behind my shop and my ladder fell. Yes, I

I know most of the folks in this group are hobbyists, and as such are probably in the shop alone most of the time. Please carry your phone on your person at all times in case of an accident. Yesterday

I honestly received this pic from an OEM regarding motor connections. Below is what original connections look like. I seriously was shocked beyond belief and literally thought the tech was starting

https://machinerymax.com/Event/LotDetails/25840604/Altendorf-F45-Elmo-4-Programmable-Sliding-Table-Saw-4Axis Imran

Oh! service rating is S followed by a number, e.g., S6. There is a nice concise chart that John Kee posted but this is what I could find.

Acharya, I am not a motor expert but here is what I can offer. The RPC I built with a used 10HP motor ran idle (no load) for 17-18 yrs until I sold it. I assumed your motor is fan cooled so, check

?Well I broke down and bought testo 405i anemometers before replacing the RL125 filter. Previous owner had used this DC with WBS and we knew that it is plugged with fine dust to some extent. I

That’s a great idea! Elwin

Sharing a potential storage location for the Felder parallel guide arm. I stumbled on the idea when changing out the factory dust guard bolts with stainless ones at first wanting to use the tube as

I'm planning on replacing my Minimax 300 CU; year of manufacture: 2000. For several years I have experienced overheating of the saw and shaper motors when running the machine for extended periods,

I had a similar problem with my A31, then I realized that I had not fully locked the outfeed table down in place with the lever. reset and put equal pressure on each lever and problem resolved.

It’s the standard low cost table fence from felder *Drew Tosh* *Co-Owner* <http://www.woodwerd.com/> *WOODWERD <http://www.woodwerd.com>* 413 S Frontier Ln Cedar Park, TX 78613 *Main: 512-553-9663*