I had a similar problem with my A31, then I realized that I had not fully locked the outfeed table down in place with the lever. reset and put equal pressure on each lever and problem resolved.?
On Thu, Jan 21, 2021 at 8:50 PM mark thomas <
murkyd@...> wrote:
I'm not sure I follow this.? If the outfeed table is .050" higher than the cutting arc, then after about 1" of jointing, the wood would hit the .050" higher edge of the outfeed table and come to a dead stop.? So the jointed is completely unusable.? Is this what you're saying?
