开云体育

took a quick look. looks good. Imran

I have great experiences with Quinn as well.? They sharpened a wide variety of blades for me from Lamello blades to Festool blades with variable spacing to my Forrest, Felder and Morse metal blades,

There is a balancing act that goes with low pressure impellers used in most hobby collectors. Machines range from small jointers with 4" ports to larger shapers with two 5" ports and the cutter

Thanks?

I can’t help you with the original thread but be very aware that the wee pivoting panel that they give…depending on what size power feed you go for and whether you are intending to use it on the

I found this: https://www.spiralmfg.com/wp-content/uploads/2015/09/dust_collection.pdf I think this might do the trick for me.

Thanks Lucky, Good to know the Felder solution isn't viable. I'd hope that we would be able to put it on and leave it there, but in reality that won't happen. We have done away with the stock fence,

David, granted it has been a while, but I do not recall any consideration to horizontal vs vertical in the calculations. Imran

I asked the question because my spidey-sense was telling me it could be an issue, but I lacked the right knowledge to articulate. I’m doing something so simple: dropping through the floor from my

I was told there was a not too distant thread regarding mounting a power feeder on a Hammer C 3-31. Can anyone help direct me to that source or provide suggestions

From Wynn Environmental's FAQs RE rotating arms in filters: "Q: Do any of your filters have cranks with paddles? A: No. Paddles rub the filter media and pin-hole leaks will develop. Our filters

I am not sure any wiper solution works for dislodging fine dust in long term. You need reverse pulse jet cleaning that is becoming common on higher end systems. Imran

Jason...thanks for sharing your experience on the CV.? The main deficit for these systems is fine dust collection AND clogging of the filter.? Some of the systems out there have a feature where one

Thanks, They are in St. Louis so that is nt too distant

I was happy to see that the cap would ship same day, even though i placed the order after 2pm. Got an email saying it did not ship yesterday but would ship today and is coming next day air. That is

Jason, Generally I agree but for where I live, Rockler had the best price for the gauge offered for the spiral pipe and many fittings. Imran

I would also recommend Quinn Saw Company. They’re a 5th generation family company and have great customer service and stay up on the latest technology. John Adank Onalaska, WI

Jason: You can buy an infeed extension table (with leg) that fits on that round bar. It is diabolically complicated and fiddly to set up. And it weighs a lot because it is pressed steel rather than

We have a FB540? bandsaw in our shop. I posted a while back about the new belt feed resaw feeder we picked up at auction for it. The thing works phenomenally. The one thing that would improve the

A couple of observations. One, don't buy anything at Rockler if you can get it elsewhere. Their pricing on most things is ridiculous, hardware in particular. As someone else noted, you've got quite a