开云体育

Dmitry, I was warned to stay away from the sanding drum kit on shaper due to RPM being too high. Do you have variable speed on shaper? Imran

Hi, Cleveland area but willing to drive.

Dmitry, Didnt know that was an option for my KF700SP that is on the way Is!? Is the fact that is is non oscillating going to make it less usable? PK

Overkill !! Why not just buy head for shaper from felder different diameters. That’s what I’m using if need it Elegance Custom Cabinetry Minneapolis, Minnesota Regards Dmitry Ivanovs .

They are part of the outer motor housing extrusion. I would check with Felder and if they are ok with it, clamp it to a solid flat surface before you install it and see if you can pull the flanges

Hey All, I was wrong about the key. ?On closer inspection, it was not welded and just needed to be tapped in. ?Not sure if I should attempt with the Bent rails though. -Annu

Annu, what is the frame size of the motor? It looks like the feet are aluminum. If steel I would just bend them back. Aluminum might break but I'd look for a different source if the frame is a

The label says 50 *?* F (microFarads) 450V.? I needed to replace the start capacitor on my 20 year old Inca table saw earlier this year.? Slightly larger motor (2.2 kW) than what you have here, but

Somehow I could not see it well in mail but on groupio I can see that key is ramped in the pic. Imran

Too bad. The bracket looks like AL, if that was the only item, I probably try to straighten it but key being welded is a non starter. I have not worked with a lot of motors but I have seen the ramp on

Hi Annu, I feel your frustration. I am sure this is already considered but can the brackets be transferred from old to new motor? I am not sure how the pulley is retained on the shaft but could the

Well...i'm seriously frustrated now....the new motor that was sent has a different motor shaft key than the original motor.? The new motor's key is like a ramp and the old motor's key is flat.? So

I know I am reviving an old thread, but... I was looking at the Laguna and Delta newer floor standers as they have a trunnion tiliting mechanism so the table stays flat.? Thoughts? Thoughts? PK

There are maybe 10 turntables in th UK , sods law that one of them gets listed less than an hour before I ask the question. If had the space I would buy it and keep both, but unfortunately I don't and

This is for a three-phase but looks as if it fits what you’ve got. I think you can ignore it since the C3-31 has it built-in already.

I’m thinking it might be a thermal overload option. Roger

Hi, Don't know if it is what you mean or indeed will be any help. But there is a listing on e-bay UK with a panel saw with a turntable. Never seen one before, but thought I would mention it. Regards,

I have a bf6 with the turntable. But no drawing. Doubtful this is s help. I remember when I moved my shop that the plate was odd in its configuration.

The label on the bandsaw motor lists a capacitance value in the “cond” field as shown below: The capacitor was painted same as motor and apparently the band (holding the capacitor) is suppose to

Hey Roger, I was able to lift it with a pallet jack and a extra set of 4x4s. ?See the attached picture. Question for the group...the new motor has six wires terminals and a ground on it instead of