Re: Hammer C-31 Planer Issue - Motor Triping
¿ªÔÆÌåÓýToo bad. The bracket looks like AL, if that was the only item, I probably try to straighten it but key being welded is a non starter. I have not worked with a lot of motors but I have seen the ramp on the end of key trench (perhaps due to milling) but the key sat flat and the groove on the pulley is flat. If i understand you correctly the key projection from shaft is ramped. I am curious if that is intended or an error. Imran On Jan 16, 2021, at 6:51 PM, annu.marwaha@... wrote:
?Hey Imran, the key is welded to the shaft. ?I can see the small filet weld towards the motor housing. ?The brackets are also part of the motor housing. ?I¡¯ll have to get Felder to address it. -Annu |
imran