开云体育

yes barn door is a project that requires it and i did 10 & 12 ft shiplap siding for the same addition earlier this yr. past these i will likely keep this space for J/P until i use up my air dried

Imran, your message is above and beyond. You've given me so much to think about. With your upcoming build, you're planning on the I-beam for the jamb, right? You don't think something like an LVL

I suppose I should clarify my email yesterday as it elicited a few responses both here and privately, not that we need to continue hijacking this thread in further discussion: 1. Yes, if you are

12' is really long, do you have some examples for which you needed or would need 12' that you cannot split in two. I can see a quadruple barn door system, but you can always split your top plate in

Anthony Thanks for the tip. Mike’s video is what got me tuned into the torsion box idea. And his materials and level of finish are about what I need. Bird

freud oshlun and cmt? all have? exactly that ?and they are on amazon 12/9/20 8:11 AM, john adank wrote:

My shop is a two car garage with a 16' garage door and a side door. I have my jointer parallel to and about 18" from the garage door and inline with the side door. If I need to joint something long I

Hi Drew: I'd be grateful for the Fusion CAD file for your torsion box. I need to replace my assembly table top and this looks like a much better solution than the Home Depot countertops I'm currently

Bill, it may look like unused space but literally there is none to speak off. the 6’ xcut fence & outrigger sweeps the space as far as the slider reaches on outfeed. xcut fence scrapes by the drill

Buy a 48t ATB or TCG and have it reground Regards, Mark https://www.instagram.com/kessler_woodworks/

John, would ATBR grind work? no bat ears. http://www.tenryu.com/300.htm in above they call it ATAFR. if this does not work you can call them. they have been very helpful to me in past. imran

Thanks Imran, I agree that it is cramped :) and you have a lot of unused spaces. I just have rough ideas now, but the center of the room has to be free in my mind to allow for passage or for your

Is anyone aware of a manufacturer that makes a 12” Flat Top Box Joint blade? I may just have to go with a 10” blade bored with a 30mm hole from Ridge carbide or somewhere else. John

Any recommendations for a Tenryn supplier in Europe...... when I've looked the postage from US to Europe is crazy. Jonathan fineinteriorwoodwork.com richardmartinwindows.com

Brett, Been running several business for +20 years and helping many others I've seriously doubt that equipment investments in the range 50 - 150k would challenge a serious business. You can lease that

I have a Tenryu cross-cut blade that I'm impressed with. -- Bill Hope ( https://dnisw.com ) -- Measure it with a micrometer, mark it with chalk, cut it with a Hammer

Rodger I would have a look at what CMT have, I use there rip blades and there ok, Scott and Sargent's stock CMT Jonathan fineinteriorwoodwork.com richardmartinwindows.com

Ordered one from Felder UK with the expectation given of it arriving within 5-6 days. Now told out of stock…should be at Felder in 10 days or so….which takes us to Christmas and shutdown etc so it

Congratulations! ?What is the deal with that accessory table top that appears to be shop made?

There is a local cabinet shop that does a surprising bit of work, is decades old and it's like this: 1. table saw with large plywood extensions to handle sheets. Sheets get stacked vertical on floor