开云体育

Lots of experience here on options and mistakes others have made. Share your thinking and you will get lots of mostly consistent input. Felder builds all machines to order and if any are available in

michal, felder makes many different tools. what are you looking to buy? saw, shaper, jointer, bandsaw, CNC, ... there are single and combo options. you can buy new or used where are you located on the

Hi everyone. I'm looking in getting a Felder. Any thoughts or tips on how to go about it? Thanks, Michal

I have the KF700SP with the 10’6” slider, and the 4’ outrigger. Sorry, I don’t think in metric, so I just used an imperial tape measure to get rough measurements. I remove the fence from the

I had a cart for my KF700 and as Jonathan said it is quick and easy. I don’t have the little ears on my 940 to use the cart so I was considering selling it, where are you located? Sent: Thursday,

Plenty strong enough, and you don’t need to ratchet, they pivot anywhere you want them. The ones I got for 5/16 studs are pretty large, so you might have to reduce the size of the thru stud on the

thanks Brian. i saw these cam action levers but they do not ratchet, which is not necessary. you think they would be strong enough for pneumatic clamps? imran

Kipp makes these in threaded hole and threaded post. They can tend to be pretty large, I bought some to try with the Flipstop and they are too big and bulky for that application. Brian Lamb

thanks Jerry. good to know. currently i have to remove the kip lever to lift my homemade clamp off slider - your suggestion should speed it up. issue is that i made the slider nut too long and it does

I use this method when you cannot fully rotate the handle. Get the appropriate T-handle hex or torx driver, lift the handle to disengage it and turn the handle mounting screw CCW. The screw does not

David, do you have the outrigger cart? It makes removal a 30 second procedure. Jonathan fineinteriorwoodwork.com richardmartinwindows.com

do they make any kip type clamping lever where the handle could be flipped vertical? it would allow easier removal where there is not much horizontal clearance to fully rotate the handle. imran

Hi David: I have separates so I have no experience using a KF700, but I’m surprised by your comment that using the shaper with the outrigger in place is a pain. For me — having no experience —

Hi Acharya, Although you haven't asked this, but having purchased the KF700S with 9' sliding table and knowing what I now know, I feel I would have been happier with the longer table. Also, removing

Nah, you can get a martini anywhere, but now if we are to get into DB’s wine cellar…

I have attached the bracket drawing that I created. It is based upon the original but uses 3/8" steel plate instead of the 1/2" AL. One I have had installed on KF700 was made with 1/2" AL plate but

Thanks for the reply. The parts list would be helpful.CHSSent from my T-Mobile 4G LTE Device

Wow that’s a lot of big machinery in a tight space. Well done!

I recently ordered a KF700S. I was considering a 2800 slider, ended up with a 3200 slider with 1500 outrigger. I did not explicitly ask about the 1300 outrigger, but I had the impression that it was

hi charles, the drawing for the custom bracket is in files section. the remaining parts are available from mcmaster carr. i can send you the parts list if you are interested. i had some brackets made