开云体育

thanks Brian. i saw these cam action levers but they do not ratchet, which is not necessary. you think they would be strong enough for pneumatic clamps? imran

Kipp makes these in threaded hole and threaded post. They can tend to be pretty large, I bought some to try with the Flipstop and they are too big and bulky for that application. Brian Lamb

thanks Jerry. good to know. currently i have to remove the kip lever to lift my homemade clamp off slider - your suggestion should speed it up. issue is that i made the slider nut too long and it does

I use this method when you cannot fully rotate the handle. Get the appropriate T-handle hex or torx driver, lift the handle to disengage it and turn the handle mounting screw CCW. The screw does not

David, do you have the outrigger cart? It makes removal a 30 second procedure. Jonathan fineinteriorwoodwork.com richardmartinwindows.com

do they make any kip type clamping lever where the handle could be flipped vertical? it would allow easier removal where there is not much horizontal clearance to fully rotate the handle. imran

Hi David: I have separates so I have no experience using a KF700, but I’m surprised by your comment that using the shaper with the outrigger in place is a pain. For me — having no experience —

Hi Acharya, Although you haven't asked this, but having purchased the KF700S with 9' sliding table and knowing what I now know, I feel I would have been happier with the longer table. Also, removing

Nah, you can get a martini anywhere, but now if we are to get into DB’s wine cellar…

I have attached the bracket drawing that I created. It is based upon the original but uses 3/8" steel plate instead of the 1/2" AL. One I have had installed on KF700 was made with 1/2" AL plate but

Thanks for the reply. The parts list would be helpful.CHSSent from my T-Mobile 4G LTE Device

Wow that’s a lot of big machinery in a tight space. Well done!

I recently ordered a KF700S. I was considering a 2800 slider, ended up with a 3200 slider with 1500 outrigger. I did not explicitly ask about the 1300 outrigger, but I had the impression that it was

hi charles, the drawing for the custom bracket is in files section. the remaining parts are available from mcmaster carr. i can send you the parts list if you are interested. i had some brackets made

hi jeff, i am glad that you got it going. sorry that you had to go thru the swap on the gas spring. imran

Just to close out on this for those who might be interested, I ordered a 125lb gas spring to try in place of the 250lb spring I had been using. It arrived this evening and I just installed it. It

thank you all for the feedback back in June. i needed to use pressure module on K975 few days ago and realized i never acted on the inability to mount aigner pressure module on xroll. i decided to

Thanks David, google popped his business right up. Sent: Monday, November 16, 2020 2:52 PM To: [email protected] Subject: Re: [FOG] Any experience with Boarke wide belt sanders I think Andy

Thanks Eric, Here is the standard announcement I give everyone about the booze cabinet in my shop: https://flic.kr/p/2ao31Uz <https://flic.kr/p/2ao31Uz> David Best

I think Andy from CO is the dealer on that one. When I was looking at WB, I was interested but he sounded a little too sales guy but to be fair, he gave me a reference for Peter Mulberger who does