开云体育

Put the selector button in reverse for the shaper, see if the yellow light comes on. If it doesn’t, you have an open connection in your e-stop string. All the limit switches and stop buttons are

Could be the motor start capacitor as James has said but the motor usually tries to start and then stops it also buzzes too! Have you got more than one motor on your machine, if so it’s unlikely

Hi Toby! First port of call is checking the input and output from your control transformer assuming you have checked all the supplies etc. The control transformer basically supplies power to the

Once in a blue moon this happens here. Blowing out the electronics and switches, including under the covers with compressed air has removed dust and seems to have solved the problem.

More info 1phase 3 phase , vfd ? martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

Toby, Just had a similar situation with my N4400. ?I would recommend checking the motor start capacitor. ?Likely a visual inspection will tell you if it’s bad. ?The capacitor on the N4400 was mad

Felder Folks, I used my the Shaper this morning, then switched to saw and it is not starting. I’ve tried: * Power cycling * Fuses checked with ohm meter * Safety switches properly engaged *

Here is a source with some good info and links, https://machineatlas.com/machines/inca-euro-260/ Jerry P *Life is what happens to you when you're making other plans.* "You can observe a lot by

Thanks Imran. I do have a volt meter and will try to check. Good stuff. Alan

Alan, here is the link for relay https://www.ebay.com/itm/141902737073 datasheet: http://www.farnell.com/datasheets/1885112.pdf it is 24V SPST NO relay with following pin configuration: when there is

Cut the pallet up and remove were you want the Oak skids to go Attach and roll out. Just need a reciprocating saw and BFH and pry bar just beet what you don’t want out trash it. Than change the

Thanks Mark. It is funny about these little Incas. Everyone seems to have affection for them. I got mine for free from the original owner who didn’t want to restore it. Other than the switch

I have the same inca bandsaw, I thought it was a regular ol’ switch. Jessie will take care of you, i bought the Inca bandsaw and the 2100 TS from him in 92’. I sold that tablesaw about a year ago

Thanks David. Yes, I already have an email off to Jesse, as he used to sell Inca tools and Eagle Tools is a great source. I also tried Garrett-Wade (their phone number is on a sticker on the machine,

Great idea Imran. Thanks I’m not competent to do that, but I can find someone who is. Alan.

Alan, are you able to verify that the siemens relays are working or not. i do see them available via internet search on PN. imran

Thanks TJ Cornish. There is a safety interlock, but it appears to have broken a long time ago and the two wire from the interlock are joined to bypass. The former owner inked a note on the cover that

Jesse at Eagle Tools in L.A.

Are there safety interlocks on the machine? If not, any generic magnetic motor starter set for the appropriate motor current should be fine.

I have an old Inca Euro-260 bandsaw - very nice small complement to my larger Felder FB600 bandsaw - but unfortunately the on/off switch died. ?I tried to get parts from incamachines.com in France.