开云体育

Thanks All, I think I am going to give it a shot, I will setup some form of better venting and may have the insides shot with a bit of spray foam. Thanks Glen, Alpine Moulding and Millwork Inc. Mail:

I vote to blame it on Mac too. LOL Bill Belanger

Well, it’s Mac’s fault then…. Brian Lamb blamb11@... www.lambtoolworks.com

The spacer block I added was specific to the Comatic Smart Stand - to make it possible to swing the power feeder across the fence. Using the the power feeder stand from Felder, a spacer block was not

Brian is correct. ASAIK a riser is only required with smart stand to clear the fence. when i had a custom bracket fabricated for dual51, with ~6” riser, for smartstand installation a discussion

If I did that, then I would think the first post of this new thread would me mine. ?Mac's is the first post of this thread version. ?Maybe Mac thought this was such an important topic that it

I see the problem, somehow you have created two separate threads with slightly different titles. Brian Lamb blamb11@... www.lambtoolworks.com

I almost bought something from them.? I preceeded the? purchase with a query about? tolerances? run out that sort of thing. They sent me a hat. No specifications were available. Baileigh? doesn't

Oh...not the same title. ?My title was "Aigner Distometer Alternative" and these posts have the title "Aigner Distometer Up Alternative". ?Huh.

I would appreciate that. I have a spare power feeder I was planning on using with the jointer but other projects came along that I haven't pursued this lately. Thanks, Dave [email protected]> wrote:

Oh.... now when on the main page by topics I see that this topic is in 2 parts with the same title.

I wonder if this is a system-forum problem. ?I do not recall seeing this happen before. ?Brian, I also see my original post on this topic when searching by messages, confirming it was not deleted.

Dave – Well, I could, but due to tight quarters where the machine resides, I removed the bracket so I can push the machine back that extra few inches for additional “leg room” in my garage. If

David B and others have had to make the spacer to work in conjunction with using the Smart Stand if memory serves me right. Works fine with the standard PF mounting post. Also might need the longer

Skip, Very interesting. Can you post some pictures? Thanks Dave [email protected]> wrote:

My AD 941 came with a PF mounting bracket installed in pre-drilled holes (I ordered it that way). I think, as David Best has pointed out, for it to work practically, you need to make a spacer block to

You should check with Felder, they will surely know more than us... Regards, Mark https://www.instagram.com/kessler_woodworks/?hl=en

It will work on the AD951. But as far as I know not the AD941 Dave wrote:

Dave you should check with John as to how he knows it will work. Andy Sent: Tuesday, July 28, 2020 3:12 PM To: [email protected] Subject: Re: [FOG] AD941 vs. Baileigh JP-1898-NC Could be,

If you look at the topic, a lot of messages are not there, if you look at messages, they are all there. Not sure why, but no messages have been removed. Brian Lamb blamb11@...