开云体育

My tried and true method is to cut my edge banding about 1/2” thick and use drywall screws spaced about 6” to hold it in place. Cover the screw heads with wood filler. Never fails. Ron Magliocco

1 day Bill Belanger wrote:

Once tech arrives. machine is unpacked and everything is neat and ready to go. how long does it take to commission?

I would just use flat joint and glue and overlap edges to trim later , no advantage to all the extra step. I just use a couple micro pinner To position and than clamp edge to edge.

I've always done edge banding with the iron on strips. Now that I have a shaper, I'd like to actually use hardwood edging. I retrospect, I could have used my router table too. I'm thinking I'd like

Hey John - Are you using manual methods to shape to fit? Wondering if anyone has the digital outline of the K700 version so I can fabricate it with the CNC.

Thanks to everyone for the help. I did make one but I didn’t think to angle cut it to add material for strength. I’ll make another one with the angle cut for more strength.

They calls it "Torbandschraube" per the KF 700 SP schematic drawings.? It's an M8 size bolt.? Google translates it to "carriage bolt."? Is it unusual for European to use this type of bolt? SW

I use ridge carbide https://ridgecarbidetool.com/ They do my ends mills? and? saw blades, specialty? & custom tooling too

I think that the video shows a more completed procedure?than needed. I used 5/16" thick Garolite from McMaster-Carr that is the correct thickness. I tapered the side that goes under the slider for

Resurrecting this thread, for trimming thicker, solid wood edge banding I completely forgot to mention the Betterly flush trim router setup: https://betterleytools.com/products/flush-trimmer.html This

Where's the chuck for it?

Yes.. you want to send your blades to Quinn saw in St. Louis.. Best sharpening service I've ever seen

I don't know how different they would be; here's a video for making an insert for a Hammer https://youtu.be/8X_vd-T3hqk I'll be making one once my B3 is delivered. -- Bill Hope ( https://dnisw.com )

Just the rip fence which you can tilt backwards and get off the table, and the mounting post for the overhead saw guard. David Best

Where are you located? A place has been recommended here in St. Louis. Leitz is in Ground Rapids, MI. I am sure Leitz have other locations. I am sure there are west coast options which I have not paid

I didn’t know carriage bolts were in the vocabulary of Austrians. :-) David Best - Sent from my iPad

See attachments

Any recomendations for saw blade sharpening service? I've had poor local quality and lost touch with previous high quality vendors except Forrest. red

Schematics of the K vs. KF overhead saw guard and the locking/release latch that David is referring to. The overhead guard of a circa 2019 KF 700 SP rests on a carriage bolt when it is in its default