开云体育

Have a set of "Big squeeze" air clamps for sale. I haven't had the time to properly install these on my current saw and have used them a few times and they work awesome. Just not using them enough to

Sorry, didn't realize that the group was truncating the address. It is blamb11 at cox dot net, or you can alwass reply down by clicking below on all messages where it says "reply to sender". Brian

Brian, I can't figure out how to get your entire mail address, but I am interested in the hammer chute

Would be much appreciated, thank you!

Yes that’s the Extrema rail-master coping sled. I love it to bits, makes coping a breeze. One cool feature it has is an air cushion in the base when you flick the air clamp on. This helps it glide

I’ll have to get a better look at it tomorrow, hoping that’s the easy fix for it.

Glad it's working for you. I only had pictures to go by and it looked like that flange around the top would hit the belt cover on the motor. Brian Lambblamb11@...

HI Dan, That was what i thought initially but when i check it with a straight edge, the castings were machined spot on. It does end up spot on though after a good clean up, it's just that sometimes it

Jup it clears everything. Been working great for the past few weeks. I my case i added a slight bend forwards because if have to clear a homemade throughput for an extra on off switch on my sliding

Does that clear everything? Pictures I have from Tom look like it wouldn't on the side closest to the blade. I had to remove the bolt on that side completely. Brian

Dan, a service ticket is most likely needed as I have the same machine and cannot locate any type of mechanism/bolt/nut or adjustment means.? Out of curiosity, is the turqouise colored device some

Not to be a killjoy but i recently designed the same: https://www.printables.com/model/1250208-hammer-c3k3-hose-connection

Hello Nentanel, Thanks for offering to organise getting a batch of these made up can you please put me down for a kit for two machines please. Hopefully you get enough interest in this project. Just

Hi Brian Since I live in Europe buying a printed model is off the radar. Are you willing to sell the stl and/or fusion file? Regards Bram Baert Op wo 2 apr 2025, 02:14 schreef Brian Lamb via

Bryce, it almost seems as if the attachment mechanism doesn’t retract enough to pull it tight or the surfaces were not machined properly. Could Also be a defective fence plate. I’m putting in a

Unfortunately an aigner fence is just not in the budget at this point. I’d rather upgrade the machine to a format 4 shaper than invest more into this model.

Felder BF6-26 Located 10 miles North of Boston. I can provide lots of pictures if there is any interest. #forsale

Isn't it just an excuse to get an Aigner fence? ? On mine the previous owner had added some packing tape to make everything coplanar -Karl

Thanks, Mike D! Some folks in this group have mentioned issues with getting things clean and screws torqued correctly. Definitely prudent to check YouTube. -- John Hinman Boise ID Kappa 450X and

Straight knife, the scallops are at a right angle to the material passing through the machine spiral heads the scallops are running linearly with the board martin/campshure/co/llc mac campshure 7412