On Apr 2, 2025, at 3:11?PM, Bryce Comer via groups.io <bryce@...> wrote:

?

HI Dan,

That was what i thought initially but when i check it with a straight edge, the castings were machined spot on. It does end up spot on though after a good clean up, it's just that sometimes it catches me out when i start to run something and then notice it. That first piece is normally a test piece anyway, so not an issue.

Regards,

Bryce

--

https://www.brycecomerwoodworks.com/
https://www.youtube.com/channel/UCHdrRaAZd_pOa7wwbdNPUEw