开云体育

Hi Imran, That’s interesting to know. When I get back to the shop I’ll have to see if I have one in that groove. Thx, Wade

Hi Mike, Can you confirm that the table itself is flat but you see the variation on the dial gauge as you described? Imran Malik IAM Wood

Just so you know, Felder tables are extruded and then machine hammer tables are extruded martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

Tables pretty light duty what I would do is put it between two sawhorses and stand on it. You have to jump on a little bit. That should straighten it out unless you have a

I have the same sliding table, though on a K3. I have never attempted to measure how flat the sliding aluminum table is along its length--which is what you're referencing, if I understand correctly.

I highly recommend looking up changes your whole outlook on life martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

That’s what cat litter is for martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330

Hi Wade, There is a stop on the 1100 xcut fence. This is the only way to keep the scale accurate. The stop goes in the channel where blocks slide. The stop had a set screw fixing its location. The

I'm going to have a two post lift and do auto repair in the front half of that picture and I don't want to get the concrete stained. Dave Davies [email protected]> wrote:

My question is why what’s wrong with the nice concrete floor you’ve got seems like a nice to me. It’s a shop floor. It’s not your kitchen. martin/campshure/co/llc mac campshure 7412 elmwood

Thank you Netanel. David mentioned on his Flickr video, regarding this upgrade, that probably 9 out of 10 1100mm cross-cut fences do not register accurately each time they are put on, taken off, put

Hi F.O.G, I have a 2007 Kf700 and the electronic rise and fall of the blade has stopped working. When I try to adjust blade height the motor makes a grinding noise but there is no movement. I have

Hi Dave Davies, Trucor LVP is bullet proof in my opinion! Great stuff and installs easily, in both directions too. Thx, Wade

Interesting Brett. Imran Malik IAM Wood Creations https://www.facebook.com/groups/362481112015700/?ref=share

Actually that used C3-31 for 10K looks pretty well equipped, I would be tempted if I wasn't so in love with my 'antique' 1999

Hi Aaron, I had a chat with Ruan (head of Felder) maybe a yr ago when they seem to have opened up used machine sales to any brand and seemingly without any checks. Someone had a bad experience and

Anecdotal but I wonder where CVTs could be today if it weren't for the F1 ban on them after Williams Racing made tests runs that indicated a 1-3 second per lap advantage over fixed gear configurations

Hi Imran, I also saw that, but it seems suspicious because the ad only has boilerplate web product photos and does not give an exact table length.? I would be highly cautious on this one and would

Any thoughts on using vinyl tiles for a workshop floor? https://www.armstrongflooring.com/commercial/en-us/products/vinyl-composition-tile/std-excelon-imp-texture/item/51860.html with 4,000 sq ft to

I was trying to figure out what was going on to as I'm respond via email as well. Thanks for the feedback i'll try and keep the videos separate from now on.