开云体育

Hi Imran, Unfortunately, at least on my planer, even long boards produce significant snipe at each end of boards <.5"... Perhaps my planer is not performing correctly? Thinking further, though, you

Hi FOGers, This post is about the resolution of a problem that I experienced with my 2008 Felder CF741P (combination machine). The issue occurred (and was resolved) several months ago, so my apologies

From the description on their website, this seems to contradict the one motor suggestion: They will supply three-phase 230V power from a single-phase 230V source for a single or combined loads. I

Hi All, I need to replace the 3P rotary converter that runs my BF7-41 combination saw/sharper/plainer/jointer. The plate lists it at 4Kw and 14.5A. I have been planning on purchasing the 7.5HP 26A

Sorry if this is not 100% on topic but how thin would you dare go with a board on an AD941? Bill Belanger

Uni strut is your friend good for all kinds of stuff so if you want to make some shelf supports that are going to be strong and reusable and other places pick up some strut and shelf brackets Simic

Try double backed tape on a carrier board double backed like outdoor 2 inch wide carpet tape s nothin stuff works well. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106

John, That looks great! My shed was built with 24" OC studs and is not made to hold stuff up on the walls.? I have two sheds and this one was something I paid to have built and installed, the other

I run thin stuff through a drum sander for final thicknessing, or if the piece is so short I cannot cut a bit of snipe off. My 15” Powermatic will mill 0.4” material reliably. One more pass

Why can’t you mill a long board at 0.4” and then cut it into shorter pieces? Should not be an issue. I have done 1/2” on dual 51. Imran Malik

Fellow FOGers: My work frequently requires me to produce precise, small parts. Several years ago, in response to a related post on this forum, I was told about the "Fritz & Franz" jig.? This simple

I have made shelving for lumber and for other material several times. I mill 2x4 spacers to a consistent thickness, straighten one edge, and laminate them between 1x4 sides. I make the horizontals out

Late to the thread here, but hopefully this might be useful. Why not shape the zebrano uprights to their final shape, apply the edge veneer, and then cut the half laps? You’d need to create a cross

I used 1/2" pex to get from my compressor on the south side of my shop to the slider on the north. The shop is wood frame and I ran the pex from the compressor into the wall cavity to the attic and

I store all my wood vertically. It's much easier to find and retrieve boards.

I have been thinking a car lift system could be modified to work for high density storage.? Each level lays on a piece of plywood or frame with spacers attached below.? Swing the arms in just above

Depends on what you plan to do with it. Everybody has covered the option to just charge the clamps. Almost anything will work. If you want to get serious, like an HVLP system, then you're into a whole

Good find on all the timber PK. A friend builds little storage areas around their garden.? Racking constructed with 4 x 2s and have tin sides and top.? The ends are open.? They have a big garden

Netanel, I assume you are asking me. All 3 machines have pressure regulators. The hose reel is at compressor pressure. The compressor sits under rip extension of K975 saw and I cannot see the dial of

Netenal, U need a minimum of 1 gallon compressor to operate clamps,Clamps come with osha shut off valve and adjustable regulator and water seperator i pre set at 60# with 90# magnet mount with non