Try double backed tape on a carrier board double backed like outdoor 2 inch wide carpet tape s nothin stuff works well.
Designing and building for 50 years
toggle quoted message
Show quoted text
On Jul 19, 2024, at 12:03?PM, John Hinman via groups.io <jhinman1911@...> wrote:
?
I run thin stuff through a drum sander for final thicknessing, or if the piece is so short I cannot cut a bit of snipe off.
?
My 15¡± Powermatic will mill 0.4¡± material reliably. One more pass through the drum sander if needed to take care of snipe, or if I get a little tear out.
For 0.05¡± strips for filling bandsaw kerfs I joint a board, rip a slightly over thick piece on a bandsaw, and then use a drum sander to get an exact thickness.
--
John Hinman
Boise ID
K700S and A941
