开云体育

I was hoping someone can help me verify dimensions of my C3 31 combo. I’m looking for the arbor length needed to run the dado blade from Felder. ?Then also what makes a saw compatible or not for

Just when I thought I was done, I find myself struggling to get this right. I seem to get things aligned within .003-.005” between the infeed and outfeed tables. So I’ll joint something then plane

Not a hose solution but I purchased a large roll of floor matting, unused,? at a flea market, the kind that is used in trucks that haul cattle. It's about 1 inch thick indestructable very comfortable

I don’t see the CNC listed on wood web. Do you have additional information? [email protected]> wrote:

?I have been rebuilding the Langzauner edge sander that was badly damaged in shipping a couple years ago. Detailed post to come later. Anyway here is the simple way I adapted the metric dust port to

The Dual51 and the RL200 have been sold. Scott

Cant install quiet option once it has shipped or been installed.

@Steve - Yes the angled part is for the micro adjust.? Unfortunately at the moment it doesn't touch the section on one side so need to work with that a little more to stabilise it.? ?At this stage

Nice work! Where is the magnetic banding, under your tape? You might have to thicken up the web on the right side, suspect the flip blade will be able to flex that thin wall, especially flipped to the

That looks awesome!? How well does it work overall?? I assume the angled part on top is for micro adjustments?? After you've made the tweaks you have to make the STL files for that housing

Hello all, Is is possible to visually determine the trunnion type on these saws from a typical for sale photo? Thank you

Hi Guys, Recently acquired a Hammer K3.? I miss the incra fence I had on my old table saw so thought I would try my hand as a micro adjust and DRO in one. I have taken inspiration from Derek Cohens

Joe you were always a few step before us, I think I bought my shaper based on your comments on Sawmillcreek. A used briquette has surfaced in my region and I might purchase it. It’s a Prodeco and

I’ve had a Comafer briquet press for 20 years. It’s been a love hate relationship. Unfortunately we over ran it with the moulder and had many issues. Totally my fault the company is fine. Just

Tom, This is exactly what I needed to know!? Thanks so much! PK

Hi PK, The automatic filter cleaning on the RL160 and RL200 is different than the RL250/300/350. Whereas the RL250/300/350 uses a volume of compressed air to directly clean the filters, the RL160 and

Tom, how much air does your RL 160 use during cleaning?? Is it like the RL250 and need a huge air supply? PK

Mac, I’d burn them in the stove in my basement shop. Certainly wouldn’t be my primary way to heat, but I wouldn’t let them go to waste. I have nearly an unlimited supply of firewood from my

Scott, I think you’ve hit the proverbial nail on the head regarding the Shaper. It’s not a sophisticated cnc and as such has limitations when compared with a more fully featured cnc machine.

At some point it's going to have to be software. Axiom is just a gimpy RichAuto pendant controller. I upgraded to a Centroid Acorn motion control system and it's a huge improvement, but the software