开云体育

James, In my experience spring or flat has been mostly effected by outfeed table height. Setting the outfeed to be .001” below the cutting edges is a trivial adjustment. I have said this time and

I need t block should be on the shelf. martin/campshure/co/llc mac campshure 7412 elmwood ave. middleton, wi 53562-3106 608-332-2330 cell airtightclamps@... airtightclamps.com

Oups!?

I am attempting to retrofit an older model F700 shaper fence to my Profil45 shaper so that I can push the fence far back enough to use router bits with the high speed spindle. The current Profil45

Jacques…… Ummm…it’s Saturday where I’m at. ??? Wade ???

…it’s Friday, time for ? off the wall ? concepts… Given that Felder positions itself as a company offering its customers ? machines built to specs ?, could we envision being able to specify

Brain, I know the jointer tables are adjustable, but it is not a trivial task. Maybe you can do a group survey to see how many people want to have a jointer producing the flat board right after it is

James, Felder most certainly can have a jointer that makes a flat board, it all depends on what setting is at when you get it. These settings are adjustable and you can get what ever cut you want. You

Got it, Thank You Andy

It irritates the hell out of me that miter saw companies (especially Festool) haven't nailed the whole dust collection thing yet (or choose not to). We are no longer living in the 1930s where inhaling

I'm running the Silent Power cutterhead. And yes...in order to get the knives 0.001" above the outfeed table, the smooth surface of the cutterhead (cutting block) needed to be 0.032" below the outfeed

Clearly, Felder is proud of their table adjustment mechanism, they think they are the best. It is the same mechanism on my 2016 AD741. I just shake my head that Felder still cannot deliver a jointer

Correct. Righty-tighty. Lefty-loosey. The latch side of the table should be unlatched when making this adjustment. Once you get the hinge side of the infeed table coplanar to the hinge side of the

? ? Andy, I fully understand your thoughts about David Best, the guy is a Walking Institution! ? Which cutter set up are you running? You mentioned your outfeed table is now 001”-.002”

Hi David, While I'm adjusting those M10 cap screws, I'm assuming: * I "tighten" them (move them upward) to move the table up * I should have the kip lever on the infeed side lightly tightened (and the

One more comment. The Hinge Pin is held in lateral position via set screws on both sides and the top shown in red arrows below. Those may need to be loosened (especially the top one) in order to get

This is the parts diagram for the hinge mechanism on the AD941. The “Hinge Pin” is item #1 (green arrow), and the elevation and slope of the table (going toward the cutterblock), is adjusted by

I think the hammer/mallet blow was in regards to lowering the outfeed table. My outfeed table as-received was quite a bit above the cutterhead knives. I loosened the height adjustment bolt, but that

Hi Andy, I have a brand new one as well, just rolled it off the pallet about two weeks ago. I’ve ordered some miscellaneous parts for it, before I start setting it up. I’ll be curious to know how

Joe, I’m sure you have a door like that left over from demonstrating at your door workshop. I’m fine to drop by and take it off of your hands so you don’t have to just throw it away… Stunning