Re: AD941 Infeed Table Adjustment
|
? ? Andy,
I fully understand your thoughts about David Best, the guy is a Walking Institution! ?
Which cutter set up are you running? ?You mentioned your outfeed table is now 001¡±-.002¡± below the cutter knives, just wondering if your running straight knives. ?I also saw a different measurement for setting the outfeed table to the cutting block, which is different from setting to knives. ?See attached pictures. ?But I¡¯m wondering if this cutter block dimension is also true for someone that is running the Silent Power spiral knife cutting block set up?
Wade
toggle quoted message
Show quoted text
On Jul 8, 2023, at 5:08 PM, Andy Pickler <andy.pickler@...> wrote:
?I think the hammer/mallet blow was in regards to lowering the outfeed table. My outfeed table as-received was quite a bit above the cutterhead knives. I loosened the height adjustment bolt, but that alone will not lower the outfeed table. For me, even striking with a mallet did nothing, and even putting 210# of free weights on the outfeed table overnight didn't lower it completely. I literally had to jump on the outfeed table directly over the supports to lower it even a few thousandths. Thankfully, I now have the outfeed table completely level/parallel with the cutterhead and between 0.001" and 0.002" below the cutterhead knives. If you want me to elaborate any more on that procedure, I can do that. I have corresponded with David Best as well, and he is top-notch in his support, his documentation, and of course his knowledge and experience. I wouldn't be as far along as I am without him.
|
